EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Investigation of the Effects of Surface and Heat Treatment on the Corrosion Behavior of Additively Manufactured AlSi10Mg

Manel Ellouz, Jan Niklas Bender, Michaela Klöcker, Hashan Wijesundara, Thomas Kordisch

Materials and Corrosion · 05.11.2026

DOI: 10.1002/maco.70303 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials and Corrosion, online erschienen am 05.11.2026. Verfasst von Manel Ellouz und 4 weiteren Autor:innen. Die Arbeit nennt 34 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This work investigates the influence of surface finish and heat treatment on the corrosion behavior of additively manufactured (AM) AlSi10Mg to provide practical recommendations for manufacturing and post‐treatment. Potentiodynamic measurements compare typical characteristic values such as corrosion potential and pitting potential for different material conditions (roughness, heat treatment) and varied chloride concentration of the electrolyte, while scanning electron microscopy characterizes corrosion effects on the microstructure. Fully polished samples show the highest pitting potential and largest passive areas, as surface roughness and low resistance of the thermal oxide layer reduce corrosion resistance in as‐built samples. Stress relief at 300°C increases corrosion potential and lowers corrosion rate but reduces pitting potential due to dissolution of the silicon network presenting large local cathodic areas. T6 treatment shows the worst performance with immediate corrosion after passing the corrosion potential, caused by coarsened Si particles and cathodic Mg 2 Si precipitates.

Zitieren

APA

Ellouz, M., Bender, J. N., Klöcker, M., Wijesundara, H., & Kordisch, T. (2026). Investigation of the Effects of Surface and Heat Treatment on the Corrosion Behavior of Additively Manufactured AlSi10Mg. Materials and Corrosion. https://doi.org/10.1002/maco.70303

Vancouver

Ellouz M, Bender JN, Klöcker M, Wijesundara H, Kordisch T. Investigation of the Effects of Surface and Heat Treatment on the Corrosion Behavior of Additively Manufactured AlSi10Mg. Materials and Corrosion. 2026. doi:10.1002/maco.70303

BibTeX
@article{Ellouz2026,
  author = {Ellouz, Manel and Bender, Jan Niklas and Klöcker, Michaela and Wijesundara, Hashan and Kordisch, Thomas},
  title = {Investigation of the Effects of Surface and Heat Treatment on the Corrosion Behavior of Additively Manufactured AlSi10Mg},
  journal = {Materials and Corrosion},
  year = {2026},
  doi = {10.1002/maco.70303}
}
Kostenlos starten →