Two‐Dimensional Plate Model Perturbation for Calculation of Stiffness and Damping Coefficients of Foil Bearings
Journal of Tribology · 18.11.2026
DOI: 10.1002/jtrb.70016 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Tribology, online erschienen am 18.11.2026. Verfasst von Rafid Imam und 1 weiteren Autor:innen. Die Arbeit nennt 29 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC 4.0). Gefördert von: Office of Naval Research.
Abstract (Originalsprache)
Foil bearings are widely adopted in high‐speed turbomachinery as oil‐free support systems, but the accurate prediction of rotordynamic coefficients remains a critical challenge. Conventional first‐order perturbation models commonly use inertia‐less spring‐dampers assigned to every nodal point of the zeroth‐order pressure grid. This study develops a new perturbation model by directly perturbing the two‐dimensional (2D) top‐foil plate equation with physical bump locations, spanwise bending of the top foil, and foil inertia. The influence of foil inertia is first examined by comparing the 2D plate perturbation model with and without foil mass. For the present bearing configuration and investigated speed and excitation‐frequency ranges, foil inertia produces only small changes in the calculated stiffness and damping coefficients. The massless 2D plate perturbation model is then compared with the conventional perturbation method using the same zeroth‐order solution. Both models predict comparable trends with rotor speed and excitation‐frequency ratio but different coefficient magnitudes. At 70,000 rpm under synchronous excitation, the 2D plate perturbation model predicts the direct stiffness and damping coefficients approximately 2.6%–14.4% lower than those obtained using the virtual independent elastic‐foundation (VIEF) model. This difference is attributed to the first‐order foil‐deformation model because the 2D plate formulation retains continuous top‐foil bending while applying stiffness and damping only at physical bump locations. The proposed method therefore provides a more physically representative first‐order perturbation formulation that captures the structurally coupled foil response.
Förderung
- Office of Naval Research
Zitieren
APA
Imam, R., & Kim, D. (2026). Two‐Dimensional Plate Model Perturbation for Calculation of Stiffness and Damping Coefficients of Foil Bearings. Journal of Tribology. https://doi.org/10.1002/jtrb.70016
Vancouver
Imam R, Kim D. Two‐Dimensional Plate Model Perturbation for Calculation of Stiffness and Damping Coefficients of Foil Bearings. Journal of Tribology. 2026. doi:10.1002/jtrb.70016
BibTeX
@article{Imam2026,
author = {Imam, Rafid and Kim, Daejong},
title = {Two‐Dimensional Plate Model Perturbation for Calculation of Stiffness and Damping Coefficients of Foil Bearings},
journal = {Journal of Tribology},
year = {2026},
doi = {10.1002/jtrb.70016}
}
EUVIMED