Development of a Non‐Covalent Molecularly Imprinted Polymer via Precipitation Method for the Selective Separation of D‐Xylose From Sugarcane Residues
Journal of Separation Science · 2024
DOI: 10.1002/jssc.70024 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Separation Science, 2024. Verfasst von Luís Fernando Tavares Borges und 3 weiteren Autor:innen. Beteiligte Einrichtung: Institute of Chemistry, São Paulo State University (UNESP), Araraquara, Brazil. Hauptthemen laut MEDLINE: Saccharum, Xylose, Molecularly Imprinted Polymers. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 55 Literaturangaben. Gefördert von: FAPESP, CNPq, National Institute for Alternative Technologies of Detection, Toxicological Evaluation and Removal of Micropollutants and Radioactive Substances-INCT-DATREM.
Abstract (Originalsprache)
The agro‐industry generates substantial waste, necessitating eco‐friendly solutions. This study introduces a novel molecularly imprinted polymer (MIPs) for the selective separation of D‐xylose from sugarcane residues. A non‐covalent imprinted polymer was synthesized via precipitation and optimized through D‐xylose adsorption assays. The polymer demonstrated an Imprinting Factor of 3.34, adsorption equilibrium within 30 min, notable reusability retaining over 95% of its adsorption capacity after three cycles, and high selectivity coefficients (α > 2.00) for all saccharides tested. The adsorption isotherm followed the Langmuir model. Characterization confirmed successful imprinting, with the imprinted polymer exhibiting a surface area of 69.4 m 2 /g and pore volume of 0.26 cm 3 /g, compared to 8.7 m 2 /g and 0.03 cm 3 /g for the non‐imprinted polymer. D‐xylose separation was tested using hemicellulosic hydrolysate from sugarcane straw and bagasse. The polymer applied as a sorbent in dispersive solid‐phase extraction with the hydrolysate achieved 90.29 ± 1.27% D‐xylose adsorption. Desorption in pure water recovered 81.48 ± 1.22% of the adsorbed D‐xylose. This method advances separation techniques, offering an efficient solution for sample pre‐treatment and expanding the application of MIPs.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Substanzen
Autor:innen und Institutionen
- Institute of Chemistry, São Paulo State University (UNESP), Araraquara, Brazil.
- National Institute for Alternative Technologies of Detection, Toxicological Evaluation and Removal of Micropollutants and Radioactive Substances (INCT-DATREM), Araraquara, Brazil.
- Institute of Chemistry, Federal University of Catalan (UFCAT), Catalao, Brazil.
ORCID-Profile: Luís Fernando Tavares Borges
Förderung
- FAPESP
- CNPq
- National Institute for Alternative Technologies of Detection, Toxicological Evaluation and Removal of Micropollutants and Radioactive Substances-INCT-DATREM
- Fundação de Amparo à Pesquisa do Estado de São Paulo
- Conselho Nacional de Desenvolvimento Científico e Tecnológico
Zitieren
APA
Borges, L. F. T., Wong, A., Silva, W. R., & Sotomayor, M. D. P. T. (2024). Development of a Non‐Covalent Molecularly Imprinted Polymer via Precipitation Method for the Selective Separation of D‐Xylose From Sugarcane Residues. Journal of Separation Science. https://doi.org/10.1002/jssc.70024
Vancouver
Borges LFT, Wong A, Silva WR, Sotomayor MDPT. Development of a Non‐Covalent Molecularly Imprinted Polymer via Precipitation Method for the Selective Separation of D‐Xylose From Sugarcane Residues. Journal of Separation Science. 2024. doi:10.1002/jssc.70024
BibTeX
@article{Borges2024,
author = {Borges, Luís Fernando Tavares and Wong, Ademar and Silva, Weida Rodrigues and Sotomayor, Maria D P T},
title = {Development of a Non‐Covalent Molecularly Imprinted Polymer via Precipitation Method for the Selective Separation of D‐Xylose From Sugarcane Residues},
journal = {Journal of Separation Science},
year = {2024},
doi = {10.1002/jssc.70024}
}
EUVIMED