EUVIMEDEUVIMED entdecken
Crossref

Computer simulation study of cementless cup placement for dysplastic hip osteoarthritis using subluxation percentage of Crowe classification

Computersimulationsstudie zur Platzierung zementfreier Pfannen bei dysplastischer Hüftarthrose anhand des Subluxationsprozents in der Crowe-Klassifikation

Keiji Otaka iD, Yusuke Osawa iD, Yasuhiko Takegami, Hiroki Iida iD, Yuto Ozawa, Hiroto Funahashi iD, Shiro Imagama

Journal of Orthopaedic Research · 2024-08 · 42 (8) · 1801-1809

DOI: 10.1002/jor.25819 ↗

Auf einen Blick

In 91 Hüften mit DDH korrelierte der cup-CE-Winkel negativ mit dem Subluxationsprozentsatz. Für AHC und 10 mm HHC wurden Grenzwerte für einen cup-CE-Winkel ≥0° bestimmt.

Fragestellung

Besteht ein Zusammenhang zwischen dem Subluxationsprozentsatz der Crowe-Klassifikation und dem cup-CE-Winkel bei zementfreier Pfannenplatzierung?

Methode

Computersimulation auf CT-Basis bei 77 Frauen mit DDH in 91 Hüften; Pfannenplatzierung am anatomischen Hüftzentrum und 10 mm darüber; Analyse mit Spearman-Korrelation und ROC-Kurve.

Ergebnisse

Der cup-CE-Winkel war mit dem Subluxationsprozentsatz negativ korreliert: ρ = −0,542 [p < 0,01] für AHC und −0,704 [p < 0,01] für 10 mm HHC. Grenzwerte: 56,1 % und 73,6 %.

Schlussfolgerung der Autor:innen

Zementfreie Pfannenplatzierung im AHC ist bei Subluxationsprozentsatz ≥56,1 % schwierig; alternativ sollten HHC-Rekonstruktion oder ein femoraler Strukturautograft erwogen werden. Bei 10 mm HHC gilt dies ab ≥73,6 %.

Kernaussagen

  • Negativer Zusammenhang zwischen Subluxationsprozentsatz und cup-CE-Winkel
  • Grenzwert für AHC: 56,1 %
  • Grenzwert für 10 mm HHC: 73,6 %

Deutsche Zusammenfassung: KI-gestützt aus dem Original-Abstract erstellt; alle Zahlen wurden automatisch mit dem Original abgeglichen. Maßgeblich ist der Original-Abstract.

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Orthopaedic Research, online erschienen am 26.02.2024. Verfasst von Keiji Otaka und 6 weiteren Autor:innen. Beteiligte Einrichtung: Department of Orthopaedic Surgery, Nagoya University Graduate School of Medicine, Nagoya, Japan. Hauptthemen laut MEDLINE: Arthroplasty, Replacement, Hip, Computer Simulation, Osteoarthritis, Hip. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 30 Literaturangaben.

Auf einen BlickAbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

It is often difficult to achieve adequate bone coverage of the cup in total hip arthroplasty in cases of severe developmental dysplasia of the hip (DDH). This study aimed to evaluate the relationship between subluxation percentage of Crowe classification and cup center‐edge (cup‐CE) angle to investigate whether subluxation percentage according to the Crowe classification is a useful indicator for cementless cup placement. Cementless cup placement was simulated in 77 women with DDH in 91 hips (Crowe I, 35 hips; Crowe II, 35 hips; and Crowe III, 21 hips) using computed tomography‐based computer simulation software. The cups were placed at the anatomic hip center (AHC) and 10‐mm high hip center (HHC). The relationship between the subluxation percentage and cup‐CE angle was evaluated using Spearman's rank correlation coefficient. In addition, the cutoff values for the subluxation percentage that satisfied a cup‐CE angle ≥0° were determined using the receiving operating characteristic curve. The cup‐CE angle was negatively correlated with the subluxation percentage in both AHC and 10‐mm HHC (correlation coefficient ρ = −0.542 [ p < 0.01] and −0.704 [ p < 0.01], respectively). The cutoff values for subluxation percentage that satisfied a cup‐CE angle ≥0° were 56.1% and 73.6% for AHC and 10‐mm HHC, respectively. Cementless cup placement in AHC is difficult in cases with the subluxation percentage ≥56.1%, and HHC reconstruction or femoral structural autograft technique should be considered as an alternative. Moreover, placement at 10 mm above AHC is difficult in cases with subluxation percentage ≥73.6%.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

Arthroplasty, Replacement, HipComputer SimulationOsteoarthritis, HipHumansFemaleMiddle AgedAgedAdultHip ProsthesisTomography, X-Ray Computed

Stichwörter der Autor:innen

anatomic hip centercementless cup placementdevelopmental hip dysplasiahigh hip centertotal hip arthroplasty

Autor:innen und Institutionen

  • Department of Orthopaedic Surgery, Nagoya University Graduate School of Medicine, Nagoya, Japan.

ORCID-Profile: Keiji Otaka, Yusuke Osawa, Hiroki Iida, Hiroto Funahashi

Zitieren

APA

Otaka, K., Osawa, Y., Takegami, Y., Iida, H., Ozawa, Y., Funahashi, H., & Imagama, S. (2024). Computer simulation study of cementless cup placement for dysplastic hip osteoarthritis using subluxation percentage of Crowe classification. Journal of Orthopaedic Research, 42(8), 1801-1809. https://doi.org/10.1002/jor.25819

Vancouver

Otaka K, Osawa Y, Takegami Y, Iida H, Ozawa Y, Funahashi H, et al. Computer simulation study of cementless cup placement for dysplastic hip osteoarthritis using subluxation percentage of Crowe classification. Journal of Orthopaedic Research. 2024;42(8):1801-1809. doi:10.1002/jor.25819

BibTeX
@article{Otaka2024,
  author = {Otaka, Keiji and Osawa, Yusuke and Takegami, Yasuhiko and Iida, Hiroki and Ozawa, Yuto and Funahashi, Hiroto and Imagama, Shiro},
  title = {Computer simulation study of cementless cup placement for dysplastic hip osteoarthritis using subluxation percentage of Crowe classification},
  journal = {Journal of Orthopaedic Research},
  year = {2024},
  volume = {42},
  number = {8},
  pages = {1801--1809},
  doi = {10.1002/jor.25819}
}
Kostenlos starten →