EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Saturation‐Dependent Two‐Phase Heat Transfer in Planar Porous Media

Gokce Ozkazanc‐Guc, James W. Palko

Heat Transfer · 15.11.2026

DOI: 10.1002/htj.70409 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Heat Transfer, online erschienen am 15.11.2026. Verfasst von Gokce Ozkazanc‐Guc und 1 weiteren Autor:innen. Die Arbeit nennt 59 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Science Foundation, Office of the President, University of California.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This article describes saturation‐dependent, pore‐level heat transfer coefficient measurements for water in the boiling regime within conical pores and considers the applicability of a modified thin‐film formulation for modeling this scenario. Measurements of transient heat transfer for planar arrays of conical pores with opening diameter and depth are used to provide description of pore level performance. For saturations from 0.1 to 0.7, base averaged heat transfer coefficients are measured ranging from approximately , respectively. The heat transfer coefficients are found to be relatively insensitive to applied heat fluxes ranging from 16 to . While analytical thin‐film models are well established for cylindrical capillaries and triangular grooves, their extension to conical pores under transient, saturation‐dependent boiling conditions has not been studied extensively. Existing analytical models for cylindrical capillaries are adapted to represent the conical pore and compared with measurements. By incorporating experimentally measured temperatures at the heat source and dynamically adjusting boundary conditions at the liquid–substrate interface, the model accounts for variations in conductive resistance and superheat as a function of saturation level of the wetting phase. Both the models and experiments show strong correlation of heat transfer with meniscus perimeter. However, the model generally predicts higher heat transfer with stronger saturation dependence. Potential geometric deviations introduced during fabrication, along with limitations in the experimental measurements and the thin‐film model, are considered for their contribution to the observed discrepancies. These findings provide insights for optimizing capillary‐driven thermal systems and enable rapid pore‐level heat transfer predictions for use in pore network models of high heat flux cooling applications.

Förderung

  • National Science Foundation
  • Office of the President, University of California

Zitieren

APA

Ozkazanc‐Guc, G., & Palko, J. W. (2026). Saturation‐Dependent Two‐Phase Heat Transfer in Planar Porous Media. Heat Transfer. https://doi.org/10.1002/htj.70409

Vancouver

Ozkazanc‐Guc G, Palko JW. Saturation‐Dependent Two‐Phase Heat Transfer in Planar Porous Media. Heat Transfer. 2026. doi:10.1002/htj.70409

BibTeX
@article{OzkazancGuc2026,
  author = {Ozkazanc‐Guc, Gokce and Palko, James W.},
  title = {Saturation‐Dependent Two‐Phase Heat Transfer in Planar Porous Media},
  journal = {Heat Transfer},
  year = {2026},
  doi = {10.1002/htj.70409}
}
Kostenlos starten →