EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Work in Progress: Use of Wood‐Based Inserts in Injection Molding

David Grundmann, Michael Mainz, Leo Munier, Fabian Dillenhöfer, Alexander Pfriem, Bernd Künne, Marcel Bartz

Engineering Reports · 2026-03 · 8 (3)

DOI: 10.1002/eng2.70707 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Engineering Reports, online erschienen am 20.03.2026. Verfasst von David Grundmann und 6 weiteren Autor:innen. Die Arbeit nennt 39 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In the context of ever‐shorter product development cycles and the necessary prototype development, the advantages of the injection molding process cannot be fully exploited because it is not possible to economically produce very small series. The aim of this study is to examine the suitability of soft tooling using wood‐based mold inserts for small batch production in polymer injection molding. To this end, various types of wood are being tested in initial injection molding trials as part of this study, and their behavior under the process conditions is being compared. Those wooden molds are milled and tested in various injection molding tests. The produced parts as well as the used molds are then examined for wear, geometric accuracy and in terms of the tensile test specimen, for their load bearing capacity. It was shown that modified materials like laminated wood or compressed bamboo resist the loads of the injection molding process better than natural materials. Also, it was shown that the parts produced have a repeatable geometrical shape. After tool setup, it was possible to produce up to five consecutive workpieces of similar quality. Tensile tests showed reproducible strength values for ABS specimens while wood‐fiber reinforced Polypropylene showed unpredictable behavior. Downsides of the new design approach are the longer cycle times which lead to material degradation and the fast wear of the wooden mold inserts.

Zitieren

APA

Grundmann, D., Mainz, M., Munier, L., Dillenhöfer, F., Pfriem, A., Künne, B., & Bartz, M. (2026). Work in Progress: Use of Wood‐Based Inserts in Injection Molding. Engineering Reports, 8(3). https://doi.org/10.1002/eng2.70707

Vancouver

Grundmann D, Mainz M, Munier L, Dillenhöfer F, Pfriem A, Künne B, et al. Work in Progress: Use of Wood‐Based Inserts in Injection Molding. Engineering Reports. 2026;8(3). doi:10.1002/eng2.70707

BibTeX
@article{Grundmann2026,
  author = {Grundmann, David and Mainz, Michael and Munier, Leo and Dillenhöfer, Fabian and Pfriem, Alexander and Künne, Bernd and Bartz, Marcel},
  title = {Work in Progress: Use of Wood‐Based Inserts in Injection Molding},
  journal = {Engineering Reports},
  year = {2026},
  volume = {8},
  number = {3},
  doi = {10.1002/eng2.70707}
}
Kostenlos starten →