EUVIMEDEUVIMED entdecken
Crossref

Improving hydrodynamic injection in capillary electrophoresis by using the integral of pressure

Eric Tavares da Costa, Claudimir Lucio do Lago iD

ELECTROPHORESIS · 2024

DOI: 10.1002/elps.202300242 ↗

Kurz gefasst

Fachartikel in der Zeitschrift ELECTROPHORESIS, 2024. Verfasst von Eric Tavares da Costa und 1 weiteren Autor:innen. Beteiligte Einrichtung: Department of Fundamental Chemistry, Institute of Chemistry, University of São Paulo, São Paulo, Brazil. Hauptthemen laut MEDLINE: Electrophoresis, Capillary, Hydrodynamics, Pressure. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 23 Literaturangaben. Gefördert von: CNPq, Brazil, FAPESP, Brazil.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

A careful analysis of the typical devices and conditions used during hydrodynamic injection in capillary electrophoresis shows that the Hagen–Poiseuille model for the laminar flow is valid, even during the transitions of pressure. Therefore, the monitoring of pressure becomes a reliable approach to evaluate the effective injected volume, because the volume is proportional to the integral of pressure (IoP) over time. A piezoresistive sensor was used to monitor the air pressure at headspace of the sample vial. A set of 18 injections at 50 mbar and different times were used to evaluate the use of the normalization of the peak areas of the analytes by the IoP to compensate for imperfection during the injection. There was a significant decrease in relative standard deviation (RSD), and the proposed approach presented results similar to the use of internal standard. In addition, a microcontroller was used not only to monitor the pressure but also to command a peristaltic pump and a solenoid valve creating a system that dynamically controls the applied pressure and stops the injection when the desired value of IoP is reached. The system was used in a proof of concept in which different combinations of pressure and time were used: 10 mbar × 50 s, 25 mbar × 20 s, 50 mbar × 10 s, 125 mbar × 4 s, and 250 mbar × 2 s. Despite the constraints posed by the flowrates of the peristaltic pump and the solenoid valve, the microcontroller effectively conducted the injections across this extensive range of conditions, resulting in an IoP RSD of 2.7%.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

Electrophoresis, CapillaryHydrodynamicsPressureEquipment DesignReproducibility of Results

Stichwörter der Autor:innen

Hagen–Poiseuille equationhydrodynamic injectioninternal standardlaminar flowpressure sensor

Autor:innen und Institutionen

  • Department of Fundamental Chemistry, Institute of Chemistry, University of São Paulo, São Paulo, Brazil.

ORCID-Profile: Claudimir Lucio do Lago

Förderung

  • CNPq, Brazil
  • FAPESP, Brazil

Zitieren

APA

da Costa, E. T., & do Lago, C. L. (2024). Improving hydrodynamic injection in capillary electrophoresis by using the integral of pressure. ELECTROPHORESIS. https://doi.org/10.1002/elps.202300242

Vancouver

da Costa ET, do Lago CL. Improving hydrodynamic injection in capillary electrophoresis by using the integral of pressure. ELECTROPHORESIS. 2024. doi:10.1002/elps.202300242

BibTeX
@article{daCosta2024,
  author = {da Costa, Eric Tavares and do Lago, Claudimir Lucio},
  title = {Improving hydrodynamic injection in capillary electrophoresis by using the integral of pressure},
  journal = {ELECTROPHORESIS},
  year = {2024},
  doi = {10.1002/elps.202300242}
}
Kostenlos starten →