EUVIMEDEUVIMED entdecken
Crossref

Phase Correction for High Precision Measurement of Iron Loss Using H‐coil Method

Akifumi Kutsukake, Yukihito Kido, Tetsu Ikeda, Tsugunori Kanada, Masato Enokizono

Electrical Engineering in Japan · 2015-03 · 190 (4) · 1-10

DOI: 10.1002/eej.22449 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Electrical Engineering in Japan, online erschienen am 26.11.2014. Verfasst von Akifumi Kutsukake und 4 weiteren Autor:innen. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 8 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The accurate magnetic properties of electrical steel sheets are important for the development of high‐efficiency electromagnetic devices. In particular, the H‐coil method is a useful technique for accurately measuring magnetic field strength in a single sheet tester. Therefore, we developed a tester for magnetic field properties using the H‐coil method, referred to as the stress load type single sheet tester (S‐SST), and a problem was found in iron loss measurement at a high flux density of 1.6 T or more. In this paper, it is shown that the cause of this problem is the phase difference between the induced voltage in the H‐coil and the B‐coil. Because the phase difference makes the B–H loop slightly twisted near the tip point, the iron losses are evaluated low. Thus, we propose a method of determining the phase correction values. These values are measured in the absence of a specimen in the S‐SST measurement system, and the phase correction method for induced voltage in a coil is investigated. Finally, ideal results for the correction of iron loss in nonoriented electrical steel sheets are shown. The proposed method is effective for the calibration of a single sheet tester using the H‐coil method.

Zitieren

APA

Kutsukake, A., Kido, Y., Ikeda, T., Kanada, T., & Enokizono, M. (2015). Phase Correction for High Precision Measurement of Iron Loss Using H‐coil Method. Electrical Engineering in Japan, 190(4), 1-10. https://doi.org/10.1002/eej.22449

Vancouver

Kutsukake A, Kido Y, Ikeda T, Kanada T, Enokizono M. Phase Correction for High Precision Measurement of Iron Loss Using H‐coil Method. Electrical Engineering in Japan. 2015;190(4):1-10. doi:10.1002/eej.22449

BibTeX
@article{Kutsukake2015,
  author = {Kutsukake, Akifumi and Kido, Yukihito and Ikeda, Tetsu and Kanada, Tsugunori and Enokizono, Masato},
  title = {Phase Correction for High Precision Measurement of Iron Loss Using H‐coil Method},
  journal = {Electrical Engineering in Japan},
  year = {2015},
  volume = {190},
  number = {4},
  pages = {1--10},
  doi = {10.1002/eej.22449}
}
Kostenlos starten →