Synergistic Interfacial Engineering of ZnO‐Modified Cu Current Collectors Using Lithium Trithiocyanurate for Stable Anode‐Free Lithium Metal Batteries
ChemSusChem · 14.04.2026 · 19 (7)
DOI: 10.1002/cssc.202502753 ↗Kurz gefasst
Fachartikel in der Zeitschrift ChemSusChem, online erschienen am 27.03.2026. Verfasst von Yueh-Hsuan Chiang und 7 weiteren Autor:innen. Beteiligte Einrichtung: Battery Research Center of Green Energy, Ming Chi University of Technology, New Taipei City, R.O.C. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 50 Literaturangaben. Der Volltext ist frei in PubMed Central verfügbar. Gefördert von: National Science and Technology Council.
Abstract (Originalsprache)
Anode‐free lithium metal batteries (AFLMBs) promise high‐energy‐density, cost‐efficient storage by removing excess lithium at anode side, yet their practical use is limited by uncontrolled Li nucleation, continuous Li loss, and unstable Cu interfaces. We report a synergistic interfacial strategy using a lithiophilic ZnO‐modified Cu current collector with a lithium trithiocyanurate (Li‐TCA) coating to stabilize Li deposition and regulate Li + transport on the solid electrolyte interphase (SEI). The ZnO bottom layer provides uniform nucleation sites, lowering the Li nucleation barrier, while the Li‐TCA top layer acts as a Li reservoir and interfacial regulator, mitigating early Li depletion and enhancing stability. Optimized 5%Li‐TCA@60%ZnO@Cu anodes exhibit markedly improved Li reversibility and reduced polarization, delivering an ultralow initial plating/stripping overpotential of 12.8 mV, compared to 40.9 mV for ZnO@Cu and 76.1 mV for bare Cu. Paired with high‐mass‐loading LiFePO 4 cathodes (~17 mg cm −2 ), these anode‐free full cells show enhanced initial Coulombic efficiency and cycling stability, retaining 56.2% capacity after 100 cycles versus 47.8% and 34.6% for ZnO@Cu and bare Cu, respectively. scanning electron microscopy and X‐ray photoelectron spectroscopy analyses confirm uniform Li deposition, suppressed dead Li, and stabilized SEI, validating the dual‐function design. This scalable strategy addresses Li nucleation, SEI stability, and Li inventory, offering a promising route toward practical AFLMBs.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Battery Research Center of Green Energy, Ming Chi University of Technology, New Taipei City, R.O.C.
- Department of Materials Science and Engineering, National Yang Ming Chiao Tung University, Hsinchu, R.O.C.
- Sunway Centre for Electrochemical Energy and Sustainable Technology, School of Engineering and Technology, Sunway University, Subang Jaya, Malaysia.
- Department of Chemical Engineering, Ming Chi University of Technology, New Taipei City, R.O.C.
- Department of Chemical and Materials Engineering & Center for Sustainability and Energy Technologies, Chang Gung University, Taoyuan City, R.O.C.
ORCID-Profile: Chun-Chen Yang
Förderung
- National Science and Technology Council
Zitieren
APA
Chiang, Y. H., Anbunathan, A., Wu, Y. S., Ling, J., Chang, J. K., Chen, J. S., Numan, A., & Yang, C. C. (2026). Synergistic Interfacial Engineering of ZnO‐Modified Cu Current Collectors Using Lithium Trithiocyanurate for Stable Anode‐Free Lithium Metal Batteries. ChemSusChem, 19(7). https://doi.org/10.1002/cssc.202502753
Vancouver
Chiang YH, Anbunathan A, Wu YS, Ling J, Chang JK, Chen JS, et al. Synergistic Interfacial Engineering of ZnO‐Modified Cu Current Collectors Using Lithium Trithiocyanurate for Stable Anode‐Free Lithium Metal Batteries. ChemSusChem. 2026;19(7). doi:10.1002/cssc.202502753
BibTeX
@article{Chiang2026,
author = {Chiang, Yueh-Hsuan and Anbunathan, Ammaiyappan and Wu, Yi-Shiuan and Ling, JinKiong and Chang, Jeng-Kuei and Chen, Jenn-Shing and Numan, Arshid and Yang, Chun-Chen},
title = {Synergistic Interfacial Engineering of ZnO‐Modified Cu Current Collectors Using Lithium Trithiocyanurate for Stable Anode‐Free Lithium Metal Batteries},
journal = {ChemSusChem},
year = {2026},
volume = {19},
number = {7},
doi = {10.1002/cssc.202502753}
}
EUVIMED