EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Dental implant surface morphology, chemical composition, and topography following double wavelength (2780/940 nm) laser irradiation. An in vitro study

Peter Fahlstedt iD, Ann Wennerberg iD, Dagmar F Bunaes iD, Stein A Lie, Knut N Leknes

Clinical and Experimental Dental Research · 2023-02 · 9 (1) · 25-35

DOI: 10.1002/cre2.709 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Clinical and Experimental Dental Research, 2023-01. Verfasst von Peter Fahlstedt und 4 weiteren Autor:innen. Beteiligte Einrichtung: Department of Clinical Dentistry, Faculty of Medicine, University of Bergen, Bergen, Norway. Hauptthemen laut MEDLINE: Dental Implants. Die Arbeit wurde bisher 6-mal zitiert (Crossref) und nennt 43 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Objective

The aim of this in vitro study was to evaluate morphology alterations, chemical composition, and topography of moderately rough dental implants following double‐wavelength laser irradiation. Material and Methods Commercial‐grade titanium dental implants representing different surface characteristics (Osseospeed [OS], TiUnite [TiU], and Roxolid SLActive [RS]) were used. Laser irradiation was performed using a computer‐controlled robotic device with calibrated energy/power settings and deionized water spray. Micro‐, nano‐morphology surface alterations, chemical composition, and surface topography ( S a , S ds , S dr ) in the test group (laser plus water), control group A (water only), and control group B (no treatment) were analyzed using scanning electron microscopy (SEM), energy‐dispersive X‐ray analysis (EDX), and white light laser profilometer (Interferometry).

Results

SEM‐evaluation revealed minor between‐group differences in micro‐ and nano‐morphology within each implant system. Significant overall differences in surface element content were observed between the test and control group B for all implant systems ( p < .05). For the test compared with control group B, statistically significantly higher oxygen content was detected for OS and RS ( p < .05), a corresponding significant difference was detected for carbon for TiU ( p < .05). For RS, a significantly lower content of titanium and zirconium was detected within the test group ( p < .05). A significant difference in topography between test and control group B was observed for OS ( S a : p = .039 and S dr : p = .041) with the highest roughness value for control group B.

Conclusions

Altered chemical composition and surface topography were observed for all implant surfaces compared with untreated control following double wavelength laser irradiation. A clinical evaluation of the impact of the altered surface composition following double wavelength laser irradiation on the ability to reosseointegrate appears warranted.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

Dental ImplantsTitaniumLasersWater

Stichwörter der Autor:innen

alterationdental implantlasertitanium

Substanzen

Dental ImplantsTitaniumWater

Autor:innen und Institutionen

  • Department of Clinical Dentistry, Faculty of Medicine, University of Bergen, Bergen, Norway.
  • Department of Prosthodontics, Institute of Odontology, Sahlgrenska Academy, University of Gothenburg, Gothenburg, Sweden.

ORCID-Profile: Peter Fahlstedt, Ann Wennerberg, Dagmar F Bunaes

Zitieren

APA

Fahlstedt, P., Wennerberg, A., Bunaes, D. F., Lie, S. A., & Leknes, K. N. (2023). Dental implant surface morphology, chemical composition, and topography following double wavelength (2780/940 nm) laser irradiation. An in vitro study. Clinical and Experimental Dental Research, 9(1), 25-35. https://doi.org/10.1002/cre2.709

Vancouver

Fahlstedt P, Wennerberg A, Bunaes DF, Lie SA, Leknes KN. Dental implant surface morphology, chemical composition, and topography following double wavelength (2780/940 nm) laser irradiation. An in vitro study. Clinical and Experimental Dental Research. 2023;9(1):25-35. doi:10.1002/cre2.709

BibTeX
@article{Fahlstedt2023,
  author = {Fahlstedt, Peter and Wennerberg, Ann and Bunaes, Dagmar F and Lie, Stein A and Leknes, Knut N},
  title = {Dental implant surface morphology, chemical composition, and topography following double wavelength (2780/940 nm) laser irradiation. An in vitro study},
  journal = {Clinical and Experimental Dental Research},
  year = {2023},
  volume = {9},
  number = {1},
  pages = {25--35},
  doi = {10.1002/cre2.709}
}
Kostenlos starten →