Impact of Immediate Dentin Sealing With Various Universal Adhesives on Shear Bond Strength of Dual‐Cure Resin Cement
Clinical and Experimental Dental Research · 2025-08 · 11 (4)
DOI: 10.1002/cre2.70186 ↗Kurz gefasst
Fachartikel in der Zeitschrift Clinical and Experimental Dental Research, online erschienen am 12.08.2025. Verfasst von Malin Janson und 3 weiteren Autor:innen. Beteiligte Einrichtung: Department of Prosthetic Dentistry, University of Cologne, Faculty of Medicine and University Hospital Cologne, Cologne, Germany. Hauptthemen laut MEDLINE: Resin Cements, Shear Strength, Dental Bonding, Dentin-Bonding Agents. Die Arbeit wurde bisher 5-mal zitiert (Crossref) und nennt 22 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: The author received no specific funding for this work..
Abstract (Originalsprache)
Objectives
This study evaluated the effect of universal adhesives (UAs) applied as Immediate Dentin Sealing (IDS) on the shear bond strength (SBS) of dual‐cure resin cement, both immediately and after thermocycling aging. Material and Methods A total of 180 bovine incisors were prepared and randomly assigned to six groups ( n = 15): NOC (control), Clearfil Universal Bond Quick (CUBQ), G‐Premio Bond (GPB), Peak Universal Bond (PUB), Adhese Universal (AU), and Scotchbond Universal Plus (SBUP). Specimens were cemented with dual‐cure resin cement (Panavia V5) and subjected to SBS testing at 24 h and after thermocycling (10,000 cycles, 5°C–55°C). SBS was measured using a universal testing machine, and failure modes were assessed microscopically. Statistical analysis was conducted using a Generalized Linear Model with Bonferroni correction ( p < 0.05).
Results
Significant differences were found among UAs ( p < 0.001) and after aging ( p < 0.001). SBUP and GPB had the highest SBS before and after thermocycling, while NOC had the lowest. Thermocycling reduced SBS in all groups, with CUBQ and AU showing the largest declines. Failure mode analysis showed predominantly adhesive failures in NOC, while IDS groups had more cohesive and mixed failures.
Conclusion
IDS technique with universal adhesives significantly enhances bond strength to dentin compared to conventional cementation. SBUP and GPB showed superior bonding performance, likely due to their monomer formulations containing 10‐MDP and acetone, which are known to improve chemical adhesion to dentin and promote effective resin infiltration. Thermocycling led to a reduction in SBS across all groups, highlighting the impact of aging on adhesive durability, underscoring the importance of selecting UAs with lasting adhesive strength for long‐term bonding.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Substanzen
Autor:innen und Institutionen
- Department of Prosthetic Dentistry, University of Cologne, Faculty of Medicine and University Hospital Cologne, Cologne, Germany.
- Polyclinic for Operative Dentistry and Periodontology, University of Cologne, Faculty of Medicine and University Hospital Cologne, Cologne, Germany.
ORCID-Profile: Malin Janson, Christoph Matthias Schoppmeier
Förderung
- The author received no specific funding for this work.
Zitieren
APA
Janson, M., Sun, L., Liebermann, A., & Schoppmeier, C. M. (2025). Impact of Immediate Dentin Sealing With Various Universal Adhesives on Shear Bond Strength of Dual‐Cure Resin Cement. Clinical and Experimental Dental Research, 11(4). https://doi.org/10.1002/cre2.70186
Vancouver
Janson M, Sun L, Liebermann A, Schoppmeier CM. Impact of Immediate Dentin Sealing With Various Universal Adhesives on Shear Bond Strength of Dual‐Cure Resin Cement. Clinical and Experimental Dental Research. 2025;11(4). doi:10.1002/cre2.70186
BibTeX
@article{Janson2025,
author = {Janson, Malin and Sun, Li and Liebermann, Anja and Schoppmeier, Christoph Matthias},
title = {Impact of Immediate Dentin Sealing With Various Universal Adhesives on Shear Bond Strength of Dual‐Cure Resin Cement},
journal = {Clinical and Experimental Dental Research},
year = {2025},
volume = {11},
number = {4},
doi = {10.1002/cre2.70186}
}
EUVIMED