EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Atomic Layer Deposited Zirconium Dioxide/PTFE Separators for Intermediate‐Temperature Alkaline Water Electrolysis: In Situ Characterization

Rubab Zahra, Vesa Ruuskanen, Antti Kosonen, Mikkel Rykær Kraglund, Pradipkumar Leuaa, Christodoulos Chatzichristodoulou, Jens Oluf Jensen, Matti Putkonen, Pertti Kauranen

Chemie Ingenieur Technik · 16.11.2026

DOI: 10.1002/cite.70193 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Chemie Ingenieur Technik, online erschienen am 16.11.2026. Verfasst von Rubab Zahra und 8 weiteren Autor:innen. Die Arbeit nennt 32 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Jane ja Aatos Erkon Säätiö.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Intermediate‐temperature alkaline water electrolysis (100–200°C), which improves electrolysis efficiency by reducing cell voltage and enhancing reaction kinetics, has the potential compared to conventional low‐temperature (60–90°C) operation but requires separators that remain stable above the ∼110°C limit of the benchmark Zirfon UTP‐500. Building on our previous demonstration that microporous polytetrafluoroethylene (PTFE) membranes can be rendered hydrophilic by atomic layer deposition (ALD) of ZrO 2 , this work reports the electrochemical behaviour of these separators under industrially relevant conditions. In this work, two ALD‐modified PTFE membranes with different aspect ratios (membrane thickness to pore diameter) were characterized and compared with a benchmark polyphenylene sulphide (PPS) non‐woven diaphragm. The characterizations included potentiostatic electrochemical impedance spectroscopy (PEIS) in 45 wt% KOH at 30 bar, covering heating and cooling cycles up to 175°C, as well as gas‐crossover assessments in a zero‐gap flow cell at 80°C. Area‐specific resistance for all separators consistently decreased with increasing temperature, with PTFE membranes showing fully reversible resistance recovery after exposure to 175°C. Importantly, hydrogen‐in‐oxygen concentrations remained below the 2 vol% safety threshold throughout the operational range down to 50 mA cm −2 . Post‐mortem analyses via scanning electron microscopy with energy‐dispersive x‐ray spectroscopy (SEM/EDS), FTIR and x‐ray diffraction (XRD) revealed significant dissolution of the amorphous ALD ZrO 2 coating in hot concentrated KOH, whereas the underlying PTFE matrix maintained its chemical integrity. Despite this substantial coating loss, separator conductivity remained unaffected, supporting that the ALD coating primarily functions as a wetting facilitator, with ionic transport sustained by the electrolyte‐filled network.

Förderung

  • Jane ja Aatos Erkon Säätiö

Zitieren

APA

Zahra, R., Ruuskanen, V., Kosonen, A., Kraglund, M. R., Leuaa, P., Chatzichristodoulou, C., Jensen, J. O., Putkonen, M., & Kauranen, P. (2026). Atomic Layer Deposited Zirconium Dioxide/PTFE Separators for Intermediate‐Temperature Alkaline Water Electrolysis: In Situ Characterization. Chemie Ingenieur Technik. https://doi.org/10.1002/cite.70193

Vancouver

Zahra R, Ruuskanen V, Kosonen A, Kraglund MR, Leuaa P, Chatzichristodoulou C, et al. Atomic Layer Deposited Zirconium Dioxide/PTFE Separators for Intermediate‐Temperature Alkaline Water Electrolysis: In Situ Characterization. Chemie Ingenieur Technik. 2026. doi:10.1002/cite.70193

BibTeX
@article{Zahra2026,
  author = {Zahra, Rubab and Ruuskanen, Vesa and Kosonen, Antti and Kraglund, Mikkel Rykær and Leuaa, Pradipkumar and Chatzichristodoulou, Christodoulos and Jensen, Jens Oluf and Putkonen, Matti and Kauranen, Pertti},
  title = {Atomic Layer Deposited Zirconium Dioxide/PTFE Separators for Intermediate‐Temperature Alkaline Water Electrolysis: In Situ Characterization},
  journal = {Chemie Ingenieur Technik},
  year = {2026},
  doi = {10.1002/cite.70193}
}
Kostenlos starten →