EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Numerical fatigue strength investigation of wire and arc additive manufactured (WAAM) specimens based on 3D‐scans and implicit gradient model

Sulaiman Shojai, Hessam Moshayedi, Moritz Braun, Elyas Ghafoori

ce/papers · 2026-09 · 9 (2-3) · 2822-2829

DOI: 10.1002/cepa.70787 ↗

Kurz gefasst

Fachartikel in der Zeitschrift ce/papers, online erschienen am 14.09.2026. Verfasst von Sulaiman Shojai und 3 weiteren Autor:innen. Die Arbeit nennt 35 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The calculation of fatigue strength based on the actual local quality of a component offers the advantage of a more accurate fatigue assessment. For wire arc additively manufactured (WAAM) components, however, the incorporation of local quality into fatigue calculations is challenging due to the strong variability of the as‐built surface geometry. As a result, conventional local methods such as the Theory of Critical Distances, which require the evaluation of individual stress paths, are not readily applicable when a large number of surface notches are present. To overcome this limitation, a methodology is required that allows all surface notches to be considered simultaneously. In this work, a surface‐based local fatigue assessment approach is applied for the first time to WAAM components made of ER70S‐6 steel. The method combines high‐resolution 3D laser scanning, reverse engineering of the as‐built geometry, and numerical stress evaluation using the IGM to identify fatigue‐relevant surface regions without prior knowledge of crack initiation sites. The predicted locations of maximum effective notch stress were compared with experimentally observed crack initiation sites from fatigue tests. An agreement was found for 9 out of 15 failed specimens, indicating that the approach can identify critical surface regions despite geometric complexity and modeling uncertainties. This demonstrates the potential of the method for improving fatigue assessment and supporting the industrial application of WAAM components. Further investigations, particularly regarding material‐dependent model parameters, are required to improve the robustness of the method for WAAM components.

Zitieren

APA

Shojai, S., Moshayedi, H., Braun, M., & Ghafoori, E. (2026). Numerical fatigue strength investigation of wire and arc additive manufactured (WAAM) specimens based on 3D‐scans and implicit gradient model. ce/papers, 9(2-3), 2822-2829. https://doi.org/10.1002/cepa.70787

Vancouver

Shojai S, Moshayedi H, Braun M, Ghafoori E. Numerical fatigue strength investigation of wire and arc additive manufactured (WAAM) specimens based on 3D‐scans and implicit gradient model. ce/papers. 2026;9(2-3):2822-2829. doi:10.1002/cepa.70787

BibTeX
@article{Shojai2026,
  author = {Shojai, Sulaiman and Moshayedi, Hessam and Braun, Moritz and Ghafoori, Elyas},
  title = {Numerical fatigue strength investigation of wire and arc additive manufactured (WAAM) specimens based on 3D‐scans and implicit gradient model},
  journal = {ce/papers},
  year = {2026},
  volume = {9},
  number = {2-3},
  pages = {2822--2829},
  doi = {10.1002/cepa.70787}
}
Kostenlos starten →