EUVIMEDEUVIMED entdecken
Crossref

Process and welding parameter studies on influencing continuous welding for Wire Arc Additive Manufacturing

Benedikt Waldschmitt, Philipp Grebner, Yvonne Ciupack, Jörg Lange

ce/papers · 2026-09 · 9 (2-3) · 487-492

DOI: 10.1002/cepa.70708 ↗

Kurz gefasst

Fachartikel in der Zeitschrift ce/papers, online erschienen am 14.09.2026. Verfasst von Benedikt Waldschmitt und 3 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 12 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Wire Arc Additive Manufacturing (WAAM) is a robot‐controlled, welding‐based additive manufacturing process for producing three‐dimensional steel structures. The technology enables the manufacturing of geometrically complex components that are difficult to realize using conventional manufacturing methods. This article presents a systematic investigation of the influence of selected boundary conditions as well as process and welding parameters on process stability, deposition rate, welding performance indicators, and geometric characteristics of continuously welded layers for a vertical build‐up direction. Fundamental influencing factors are summarized to identify relevant parameters, research gaps, and methodological challenges. Based on this analysis, essential geometric and thermal boundary conditions and associated parameters are derived. A comprehensive parameter study is subsequently conducted using the Cold Metal Transfer (CMT) process variant CMT cycle step (CMT CS). The results are systematically analyzed for influences from the choice of shielding gas, the Travel Speed TS , and the CMT cycle number n cycle specific to the CMT CS process. Recorded welding performance indicators and geometric measurements are compared to provide information about their future applicability and to determine subsequent parameter investigations.

Zitieren

APA

Waldschmitt, B., Grebner, P., Ciupack, Y., & Lange, J. (2026). Process and welding parameter studies on influencing continuous welding for Wire Arc Additive Manufacturing. ce/papers, 9(2-3), 487-492. https://doi.org/10.1002/cepa.70708

Vancouver

Waldschmitt B, Grebner P, Ciupack Y, Lange J. Process and welding parameter studies on influencing continuous welding for Wire Arc Additive Manufacturing. ce/papers. 2026;9(2-3):487-492. doi:10.1002/cepa.70708

BibTeX
@article{Waldschmitt2026,
  author = {Waldschmitt, Benedikt and Grebner, Philipp and Ciupack, Yvonne and Lange, Jörg},
  title = {Process and welding parameter studies on influencing continuous welding for Wire Arc Additive Manufacturing},
  journal = {ce/papers},
  year = {2026},
  volume = {9},
  number = {2-3},
  pages = {487--492},
  doi = {10.1002/cepa.70708}
}
Kostenlos starten →