EUVIMEDEUVIMED entdecken
Crossref

Testing of Additively Manufactured Stainless Steel Tapered Circular Hollow Section Stub Columns

Jing Xu, Qiu‐Yun Li, Ben Young

ce/papers · 2026-09 · 9 (2-3) · 535-540

DOI: 10.1002/cepa.70629 ↗

Kurz gefasst

Fachartikel in der Zeitschrift ce/papers, online erschienen am 14.09.2026. Verfasst von Jing Xu und 2 weiteren Autor:innen. Die Arbeit nennt 12 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Additive manufacturing, commonly known as 3D printing, is an advanced production technique that enables the precise and free‐form creation of structural elements. In this study, an experimental programme was conducted to investigate the structural performance of tapered circular hollow section (CHS) stub columns fabricated from 15‐5 PH stainless steel using the selective laser melting (SLM) process. Material properties of the printed CHS stub columns were determined through tensile coupon tests. Additionally, the initial local imperfection distributions of representative stub column specimens were measured. A total of thirteen tapered CHS stub columns were tested under axial compression to evaluate their load‐bearing capacity and deformation characteristics. The experimental results, including ultimate loads, load versus axial shortening responses, and failure modes, were obtained for all the stub column specimens. The effect of different scanning strategies on the structural performance of SLM‐fabricated 15‐5 PH stainless steel tapered CHS stub columns was examined in this study. Among the three investigated scanning strategies, it was found that the scanning strategy S2 consistently produced stub columns with superior ultimate strengths compared to those manufactured using the strategies S1 and S3. Furthermore, the experimental ultimate loads of the thirteen stub column specimens were utilised to assess the suitability of the design provisions specified in the European Code EN 1993‐1‐4 for the SLM‐fabricated 15‐5 PH stainless steel tapered CHS stub columns.

Zitieren

APA

Xu, J., Li, Q., & Young, B. (2026). Testing of Additively Manufactured Stainless Steel Tapered Circular Hollow Section Stub Columns. ce/papers, 9(2-3), 535-540. https://doi.org/10.1002/cepa.70629

Vancouver

Xu J, Li Q, Young B. Testing of Additively Manufactured Stainless Steel Tapered Circular Hollow Section Stub Columns. ce/papers. 2026;9(2-3):535-540. doi:10.1002/cepa.70629

BibTeX
@article{Xu2026,
  author = {Xu, Jing and Li, Qiu‐Yun and Young, Ben},
  title = {Testing of Additively Manufactured Stainless Steel Tapered Circular Hollow Section Stub Columns},
  journal = {ce/papers},
  year = {2026},
  volume = {9},
  number = {2-3},
  pages = {535--540},
  doi = {10.1002/cepa.70629}
}
Kostenlos starten →