Experimental study on bolted lap joints locally strengthened by heat treatments
ce/papers · 2026-09 · 9 (2-3) · 1634-1639
DOI: 10.1002/cepa.70482 ↗Kurz gefasst
Fachartikel in der Zeitschrift ce/papers, online erschienen am 14.09.2026. Verfasst von Pelagia Kastiza und 3 weiteren Autor:innen. Die Arbeit nennt 21 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
The performance of steel bolted connections is frequently controlled by local failures at bolt holes, particularly bearing deformation and net section fracture. Weak regions such as net sections often govern structural behaviour, while conventional strengthening methods increase cost, fabrication complexity, and welding‐induced residual stresses. Induction hardening (IH) offers a targeted alternative by locally heating steel to the austenitisation range (≈1000 °C) followed by rapid quenching to form a refined multi‐phase martensitic‐based microstructure. This process can increase the strength of the material locally while retaining adequate ductility. It requires no welding or alloy modification and preserves a monolithic design of the steel section. In this study, IH was applied to locally strengthen S355 steel plates at critical net (reduced) areas of steel bolted connections. Through‐thickness hardening produced high‐strength multi‐phase steels meeting EN 1993‐1‐12 ductility requirements while reaching 880–900 MPa ultimate tensile strength. Four tensile tests have been conducted. Two on single‐bolt joints demonstrate approximately 35% higher bearing strength of the IH‐strengthened joints compared to their unstrengthened counterparts, with minimal loss of ductility. Additionally, two tests on multi‐bolt joints further demonstrate that local strengthening redirects failure from the brittle net section to a more ductile gross section zone, resulting in up to a sixfold increase in connection ductility. These results demonstrate that the IH can be an efficient and practical strengthening process to locally enhance both the strength and ductility of steel bolted connections.
Zitieren
APA
Kastiza, P., Skalomenos, K., Theofanous, M., & Papaelias, M. (2026). Experimental study on bolted lap joints locally strengthened by heat treatments. ce/papers, 9(2-3), 1634-1639. https://doi.org/10.1002/cepa.70482
Vancouver
Kastiza P, Skalomenos K, Theofanous M, Papaelias M. Experimental study on bolted lap joints locally strengthened by heat treatments. ce/papers. 2026;9(2-3):1634-1639. doi:10.1002/cepa.70482
BibTeX
@article{Kastiza2026,
author = {Kastiza, Pelagia and Skalomenos, Konstantinos and Theofanous, Marios and Papaelias, Mayorkinos},
title = {Experimental study on bolted lap joints locally strengthened by heat treatments},
journal = {ce/papers},
year = {2026},
volume = {9},
number = {2-3},
pages = {1634--1639},
doi = {10.1002/cepa.70482}
}
EUVIMED