EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC-ND 4.0

An extracellular glucose sensor for substrate‐dependent secretion and display of cellulose‐degrading enzymes

Pamela B Besada-Lombana, Wilfred Chen iD, Nancy A Da Silva iD

Biotechnology and Bioengineering · 2024

DOI: 10.1002/bit.28549 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Biotechnology and Bioengineering, 2024. Verfasst von Pamela B Besada-Lombana und 2 weiteren Autor:innen. Beteiligte Einrichtung: Department of Chemical and Biomolecular Engineering, University of California, Irvine, California, USA. Hauptthemen laut MEDLINE: Cellulose, Saccharomyces cerevisiae Proteins. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 20 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0). Gefördert von: National Science Foundation.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The efficient hydrolysis of lignocellulosic biomass into fermentable sugars is key for viable economic production of biofuels and biorenewable chemicals from second‐generation feedstocks. Consolidated bioprocessing (CBP) combines lignocellulose saccharification and chemical production in a single step. To avoid wasting valuable resources during CBP, the selective secretion of enzymes (independent or attached to the surface) based on the carbon source available is advantageous. To enable enzyme expression and secretion based on extracellular glucose levels, we implemented a G‐protein‐coupled receptor (GPCR)‐based extracellular glucose sensor; this allows the secretion and display of cellulases in the presence of the cellulosic fraction of lignocellulose by leveraging cellobiose‐dependent signal amplification. We focused on the glucose‐responsiveness of the HXT1 promoter and engineered P HXT1 by changing its core to that of the strong promoter P THD3 , increasing extracellular enzyme activity by 81%. We then demonstrated glucose‐mediated expression and cell‐surface display of the β‐glucosidase BglI on the surface of Saccharomyces cerevisiae . The display system was further optimized by re‐directing fatty acid pools from lipid droplet synthesis toward formation of membrane precursors via knock‐out of PAH1 . This resulted in an up to 4.2‐fold improvement with respect to the baseline strain. Finally, we observed cellobiose‐dependent signal amplification of the system with an increase in enzymatic activity of up to 3.1‐fold when cellobiose was added.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

CelluloseSaccharomyces cerevisiae ProteinsCellobioseFermentationSaccharomyces cerevisiaebeta-GlucosidaseGlucosePhosphatidate Phosphatase

Stichwörter der Autor:innen

HXT1 promoterPAH1Saccharomyces cerevisiaecellulase secretionglucose sensingsurface display

Substanzen

CelluloseCellobiosebeta-GlucosidaseGlucosePAH1 protein, S cerevisiaePhosphatidate PhosphataseSaccharomyces cerevisiae Proteins

Autor:innen und Institutionen

  • Department of Chemical and Biomolecular Engineering, University of California, Irvine, California, USA.
  • Department of Chemical and Biomolecular Engineering, University of Delaware, Newark, Delaware, USA.

ORCID-Profile: Wilfred Chen, Nancy A Da Silva

Förderung

  • National Science Foundation

Zitieren

APA

Besada-Lombana, P. B., Chen, W., & Da Silva, N. A. (2024). An extracellular glucose sensor for substrate‐dependent secretion and display of cellulose‐degrading enzymes. Biotechnology and Bioengineering. https://doi.org/10.1002/bit.28549

Vancouver

Besada-Lombana PB, Chen W, Da Silva NA. An extracellular glucose sensor for substrate‐dependent secretion and display of cellulose‐degrading enzymes. Biotechnology and Bioengineering. 2024. doi:10.1002/bit.28549

BibTeX
@article{BesadaLombana2024,
  author = {Besada-Lombana, Pamela B and Chen, Wilfred and Da Silva, Nancy A},
  title = {An extracellular glucose sensor for substrate‐dependent secretion and display of cellulose‐degrading enzymes},
  journal = {Biotechnology and Bioengineering},
  year = {2024},
  doi = {10.1002/bit.28549}
}
Kostenlos starten →