Effect of Tetrapropylammonium Chloride Quaternary Ammonium Salt on Characterization, Cytotoxicity, and Antibacterial Properties of PLA/PEG Electrospun Mat
Biopolymers · 2025-01 · 116 (1)
DOI: 10.1002/bip.23626 ↗Kurz gefasst
Fachartikel in der Zeitschrift Biopolymers, online erschienen am 11.09.2024. Verfasst von Sena Özdil Şener und 3 weiteren Autor:innen. Beteiligte Einrichtung: Science Institute, Department of Biomedical Engineering, Kocaeli University, Kocaeli, Türkiye. Hauptthemen laut MEDLINE: Anti-Bacterial Agents, Quaternary Ammonium Compounds, Polyethylene Glycols, Polyesters. Die Arbeit wurde bisher 7-mal zitiert (Crossref) und nennt 71 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Kocaeli Üniversitesi.
Abstract (Originalsprache)
In this study, poly(lactic acid) (PLA)–tetrapropylammonium chloride (TCL)–poly(ethylene glycol) (PEG) nonwoven networks were produced using PLA, PEG with different concentrations (3, 5, 7, and 9 wt%), and TCL. PEG is included as a plasticizer in PLA polymer, which has high biocompatibility but a brittle structure. The importance of this study is to investigate the effect of TCL salt on the characterization of PLA–PEG nanofibers. For this research, the cytotoxicity test system responsible for the fibroblast cell line (L929) was evaluated with the liquid absorption capacity (LAC) and drying time tests for its use in wound dressings. The addition of TCL salt reduced bead formation in PLA–PEG nanofibers and increased the homogeneity of fiber dispersion. The smoothest and most homogeneous nonwoven networks were obtained as PLA–5TCL–PEG. It was also reported that this nonwoven network exhibited liquid absorption behavior with a maximum increase of 150% compared to the PLA–PEG nonwoven network and had the highest Young's modulus value of 12.97 MPa. In addition to these tests, evaluations were made with Fourier transform infrared spectroscopy (FTIR), scanning electron microscopy (SEM), drying time test, differential scanning calorimetry (DSC), thermogravimetric analysis (TGA), and mechanical tests. In addition, high cell viability was observed in L292 mouse fibroblast cells at the end of the 24th hour, again with the effect of TCL salt. In addition, antibacterial activity was tested against gram‐negative E. coli and gram‐positive S. aureus bacteria, and it was observed that there was no antibacterial activity. Since PLA–TCL–PEG nonwoven webs have a maximum cell viability of 133.27%, they are recommended as a potential dermal wound dressing.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Substanzen
Autor:innen und Institutionen
- Science Institute, Department of Biomedical Engineering, Kocaeli University, Kocaeli, Türkiye.
- Engineering Faculty, Department of Chemical Engineering, Kocaeli University, Kocaeli, Türkiye.
- Department of Chemistry and Chemical Processing Technologies, Kocaeli University, Kocaeli, Türkiye.
ORCID-Profile: Sema Samatya Yilmaz, Merve Dandan Doganci
Förderung
- Kocaeli Üniversitesi
Zitieren
APA
Şener, S. Ö., Samatya Yilmaz, S., Doganci, M. D., & Doganci, E. (2025). Effect of Tetrapropylammonium Chloride Quaternary Ammonium Salt on Characterization, Cytotoxicity, and Antibacterial Properties of PLA/PEG Electrospun Mat. Biopolymers, 116(1). https://doi.org/10.1002/bip.23626
Vancouver
Şener SÖ, Samatya Yilmaz S, Doganci MD, Doganci E. Effect of Tetrapropylammonium Chloride Quaternary Ammonium Salt on Characterization, Cytotoxicity, and Antibacterial Properties of PLA/PEG Electrospun Mat. Biopolymers. 2025;116(1). doi:10.1002/bip.23626
BibTeX
@article{ener2025,
author = {Şener, Sena Özdil and Samatya Yilmaz, Sema and Doganci, Merve Dandan and Doganci, Erdinc},
title = {Effect of Tetrapropylammonium Chloride Quaternary Ammonium Salt on Characterization, Cytotoxicity, and Antibacterial Properties of PLA/PEG Electrospun Mat},
journal = {Biopolymers},
year = {2025},
volume = {116},
number = {1},
doi = {10.1002/bip.23626}
}
EUVIMED