EUVIMEDEUVIMED entdecken
Crossref

Preparation and Characterization of Durian Husk‐Based Biocomposite Films Reinforced With Nanocellulose From Corn Husk and Pineapple Leaf

Nattapron Siribanluehan, Piyachat Wattanachai iD

Biopolymers · 2024

DOI: 10.1002/bip.23619 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Biopolymers, 2024. Verfasst von Nattapron Siribanluehan und 1 weiteren Autor:innen. Beteiligte Einrichtung: Department of Chemical Engineering, Faculty of Engineering, Burapha University, Chonburi, Thailand. Hauptthemen laut MEDLINE: Zea mays, Cellulose, Ananas, Tensile Strength. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 64 Literaturangaben. Gefördert von: Burapha University, Thailand Science Research and Innovation (TSRI), National Science Research and Innovation Fund (NSRF).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This research explores the integration of corn husk nanocellulose (CHNc) and pineapple leaf nanocellulose (PLNc) as reinforcing agents in a carboxymethyl cellulose‐based film derived from durian husk (CMC DH ). Through a solvent‐casting method, composite films were fabricated with varying nanocellulose contents (15, 30, and 45 wt%). Analysis using Fourier transform infrared spectroscopy and x‐ray diffraction confirmed the effectiveness of alkaline and bleaching treatments in eliminating noncellulosic components. Transmission electron microscopy image revealed the rod‐like morphology of CHNc and PLNc, with dimensions approximately 206.5 × 7.2 nm and 150.7 × 6.5 nm, respectively. The inclusion of nanocellulose decreased the transparency of CMC DH films while enhancing their tensile strength, thermal stability, and water vapor transmission rate. Notably, CMC DH /PLNc(30%) exhibited the highest tensile strength at 5.06 ± 0.83 MPa, representing a remarkable 220% increase compared to CMC DH biofilm. Thermogravimetric analysis and differential scanning calorimeter results indicated that nanocellulose incorporation delayed the film's decomposition temperature by approximately 10°C. Moreover, CMC DH /PLNc(30%) demonstrated the lowest water vapor transmission rate, marking a 20% improvement. However, the film's properties were compromised at the highest nanocellulose content (45 wt%) due to observed fiber aggregation, as revealed by scanning electron microscopy analysis.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

Zea maysCelluloseAnanasTensile StrengthPlant LeavesX-Ray DiffractionSpectroscopy, Fourier Transform InfraredSteamThermogravimetryCalorimetry, Differential Scanning

Stichwörter der Autor:innen

agricultural residuesbiocomposite filmscarboxymethyl cellulosecorn husk nanocellulosedurian huskpineapple leaf nanocellulose

Substanzen

CelluloseSteam

Autor:innen und Institutionen

  • Department of Chemical Engineering, Faculty of Engineering, Burapha University, Chonburi, Thailand.

ORCID-Profile: Piyachat Wattanachai

Förderung

  • Burapha University
  • Thailand Science Research and Innovation (TSRI)
  • National Science Research and Innovation Fund (NSRF)
  • Ministry of Higher Education, Science, Research and Innovation, Thailand

Zitieren

APA

Siribanluehan, N., & Wattanachai, P. (2024). Preparation and Characterization of Durian Husk‐Based Biocomposite Films Reinforced With Nanocellulose From Corn Husk and Pineapple Leaf. Biopolymers. https://doi.org/10.1002/bip.23619

Vancouver

Siribanluehan N, Wattanachai P. Preparation and Characterization of Durian Husk‐Based Biocomposite Films Reinforced With Nanocellulose From Corn Husk and Pineapple Leaf. Biopolymers. 2024. doi:10.1002/bip.23619

BibTeX
@article{Siribanluehan2024,
  author = {Siribanluehan, Nattapron and Wattanachai, Piyachat},
  title = {Preparation and Characterization of Durian Husk‐Based Biocomposite Films Reinforced With Nanocellulose From Corn Husk and Pineapple Leaf},
  journal = {Biopolymers},
  year = {2024},
  doi = {10.1002/bip.23619}
}
Kostenlos starten →