EUVIMEDEUVIMED entdecken
Crossref

Modelling and cycle‐by‐cycle control of an electromechanical engine valve actuator with impact speed limiter based on hydraulic damper

Alessandro di Gaeta, Umberto Montanaro, Veniero Giglio

Asian Journal of Control · 2024-09 · 26 (5) · 2278-2296

DOI: 10.1002/asjc.3332 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Asian Journal of Control, online erschienen am 14.02.2024. Verfasst von Alessandro di Gaeta und 2 weiteren Autor:innen. Die Arbeit wurde bisher 5-mal zitiert (Crossref) und nennt 44 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Variable valve actuation (VVA) systems based on electromechanical valve actuators (EMVAs) enable a flexible operation and management of internal combustion engines that results in a reduction of pollutant emission and fuel consumption while improving engine power and efficiency. However, to achieve the benefits promised by EMVAs, it is of utmost importance to guarantee the catch of the valve by the system magnets with an acceptable impact speed of the valve at the end‐strokes. Valve catching failures can severely damage engine valves while high impact speeds induce mechanical wear and unacceptable noise. The soft landing control of the valve at the end‐strokes is challenging because of system nonlinearities, parameter uncertainties, and external disturbances. The complexity of the control design increases further when industrial cost‐effective solutions are sought. This paper presents a novel solution for reducing the impact speed of the valve without the use of costly position valve sensors. The proposed solution leverages on a small hydraulic damper (HD) embedded into the EMVA and a feedback cycle‐by‐cycle controller. The passive element reduces the impact speed while the controller adjusts at every engine cycle the EMVA coil currents based on pressure peaks detected in the HD to guarantee valve catching while steering the impact speed toward its minimum. The design of the controller exploits a physics‐based model that maps the pressure peak in the HD onto the impact speed and a gradient descent algorithm is adopted searching the minimum. The closed‐loop permanence is assessed in simulation by using an experimentally validated EMVA model and considering detailed dynamics of the HD. Numerical results show the ability of the proposed control architecture to reduce the impact speed and its robustness to parameters variations (oil temperature) and external disturbances (gas pressure forces).

Zitieren

APA

Gaeta, A. D., Montanaro, U., & Giglio, V. (2024). Modelling and cycle‐by‐cycle control of an electromechanical engine valve actuator with impact speed limiter based on hydraulic damper. Asian Journal of Control, 26(5), 2278-2296. https://doi.org/10.1002/asjc.3332

Vancouver

Gaeta AD, Montanaro U, Giglio V. Modelling and cycle‐by‐cycle control of an electromechanical engine valve actuator with impact speed limiter based on hydraulic damper. Asian Journal of Control. 2024;26(5):2278-2296. doi:10.1002/asjc.3332

BibTeX
@article{Gaeta2024,
  author = {Gaeta, Alessandro di and Montanaro, Umberto and Giglio, Veniero},
  title = {Modelling and cycle‐by‐cycle control of an electromechanical engine valve actuator with impact speed limiter based on hydraulic damper},
  journal = {Asian Journal of Control},
  year = {2024},
  volume = {26},
  number = {5},
  pages = {2278--2296},
  doi = {10.1002/asjc.3332}
}
Kostenlos starten →