Medialized Anchors in a Remplissage Repair Increase Glenohumeral Stability Without Significantly Compromising Range of Motion: A Biomechanical Study
Arthroscopy · 20.11.2026
DOI: 10.1002/arj.70670 ↗Kurz gefasst
Fachartikel in der Zeitschrift Arthroscopy, online erschienen am 20.11.2026. Verfasst von Marco T. Di Stefano und 9 weiteren Autor:innen. Die Arbeit nennt 39 Literaturangaben.
Abstract (Originalsprache)
Purpose
To determine optimal anchor placement within the Hill‐Sachs lesion and its effects on glenohumeral joint stability and range of motion (ROM).
Methods
Twenty‐four fresh‐frozen intact shoulder cadavers were oriented at 60° abduction and 60° external rotation. Each specimen underwent a computed tomography scan. Hill‐Sachs lesions were planned and created specifically for each specimen on 3‐dimensional reconstructed computed tomography images: a 3‐cm 3 lesion was made to every specimen; subsequently, for defects not initially meeting “off‐track” criteria, the Hill‐Sachs area was incrementally increased by 25% of the whole humeral head until reaching the threshold for “off‐track” lesion. A custom shoulder testing rig connected to an Instron E10000, combined with and C‐arm fluoroscopy, was used to test peak force to anterior translation. Subluxation was established when more than 50% of the humeral head was displaced in relation to the glenoid (force required subluxate measured in Newtons), 3‐dimensional humeral head displacement (anterior distance to subluxate measured in millimeters) using a MicroScribe, and glenohumeral ROM measured by externally rotating after anterior translation testing by applying a standardized 2.2 Nm external rotation torque under a constant 50‐N compressive load, with terminal rotation measured using a goniometer. The testing sequence for each specimen proceeded: (1) intact, (2) posterior capsulotomy, (3) creation of Bankart lesion, (4) creation of the Hill‐Sachs lesion, and the order of remplissage repair was then randomized at 3 anchor positions: (5) most lateral, (6) centered, and (7) most medial in the defect. The Bankart lesion was left unrepaired to isolate the biomechanical effects of the Hill‐Sachs repair on joint stability.
Results
Medial anchor placement provided the greatest stability as shown by a reduced anterior displacement compared with both the native shoulder (estimated ratio = 0.484, 95% confidence interval, 0.289‐0.811, P = .006) and lateral anchor placement (estimated ratio = 0.463, 0.277‐0.776, P = .004). Lateral and centered anchor placements did not improve stability relative to the native shoulder ( P ≥ .825). The force required to produce anterior translation was lowest with lateral anchor placement (estimated ratio = 0.891, 0.799‐0.994, P = .040), indicating the least amount of stability. In contrast, medial anchor placement required greater force than lateral and was similar to the native shoulder ( P = .441), confirming superior stability. ROM was similar between native shoulders and medial anchor position remplissage ( P = .980), whereas centered and lateral anchor positions showed significantly greater ROM than native ( P = .0225; P = .0002, respectively).
Conclusions
Medial anchor placement provided the greatest stability without a clinically significant loss of ROM. Centered anchor placement resulted in a slight decrease in stability compared with native but maintained near‐normal motion. In contrast, lateral anchor placement produced the least stability and the least restriction of motion. Clinical Relevance Optimizing outcomes in remplissage procedures requires a tailored approach rather than a universal technique. Surgeons should individualize anchor placement based on the specific dimensions of the Hill‐Sachs defect and the patient's functional demands. By focusing on restoring an “off‐track” shoulder configuration, clinicians can better balance the competing goals of maximizing joint stability and preserving postoperative ROM.
Zitieren
APA
Stefano, M. T. D., Gholipour, A., Blaine, S., Chow, A. K., Young, M. G., Baglien, P., Bolanos, D. A., Cote, M. P., Nascimento, R. J., & Mazzocca, A. D. (2026). Medialized Anchors in a Remplissage Repair Increase Glenohumeral Stability Without Significantly Compromising Range of Motion: A Biomechanical Study. Arthroscopy. https://doi.org/10.1002/arj.70670
Vancouver
Stefano MTD, Gholipour A, Blaine S, Chow AK, Young MG, Baglien P, et al. Medialized Anchors in a Remplissage Repair Increase Glenohumeral Stability Without Significantly Compromising Range of Motion: A Biomechanical Study. Arthroscopy. 2026. doi:10.1002/arj.70670
BibTeX
@article{Stefano2026,
author = {Stefano, Marco T. Di and Gholipour, Alireza and Blaine, Sophia and Chow, Andrew K. and Young, Michael G. and Baglien, Peter and Bolanos, Daniel A. and Cote, Mark P. and Nascimento, Robert J. and Mazzocca, Augustus D.},
title = {Medialized Anchors in a Remplissage Repair Increase Glenohumeral Stability Without Significantly Compromising Range of Motion: A Biomechanical Study},
journal = {Arthroscopy},
year = {2026},
doi = {10.1002/arj.70670}
}
EUVIMED