EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Low‐Undercooling Subzero Additive Manufacturing for Interface‐Free Biomimetic Musculoskeletal Constructs

Samantha L. Baker‐Jones, Patrick S. Grant, Malavika Nair

Advanced Intelligent Systems · 15.11.2026

DOI: 10.1002/aisy.70620 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Advanced Intelligent Systems, online erschienen am 15.11.2026. Verfasst von Samantha L. Baker‐Jones und 2 weiteren Autor:innen. Die Arbeit nennt 36 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Engineering and Physical Sciences Research Council.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Subzero additive manufacture enables the fabrication of soft biopolymeric 3D scaffolds without chemical modification. However, most approaches typically employ large substrate undercoolings to promote rapid solidification, creating distinct boundary interfaces that can compromise structural integrity and control over scaffold microarchitecture. Here, we present a physics‐informed low‐undercooling strategy that utilizes solidification within a mushy state, enhancing interlayer continuity while preserving macroshape fidelity. Thermal modeling guided the development of a cooling protocol implemented on a modified commercial printer to manufacture collagen and hydroxyapatite‐loaded gelatin constructs, representing fibrous and mineralized musculoskeletal tissues. Electron microscopy and X‐ray computed tomography revealed monolithic, fabrication‐interface‐free scaffolds with highly interconnected microporous networks (>99% z ‐connected pore fraction), hierarchical pore‐size gradients, and vertically aligned pores antiparallel to the primary heat flow direction. Mechanical testing showed that material composition mainly controlled compressive behavior, whereas print architecture more significantly influenced tensile performance. Concentric infill architectures increased the linear tensile modulus of collagen scaffolds by ∼70% compared with conventional rectilinear architectures, without affecting failure strain, consistent with improved interlayer bonding and load transfer. This low‐undercooling cryoprinting strategy overcomes a key limitation by eliminating weak interlayer interfaces through controlled solidification, while displaying tunability of mechanical performance through architectural control for biomimetic musculoskeletal tissue engineering.

Förderung

  • Engineering and Physical Sciences Research Council

Zitieren

APA

Baker‐Jones, S. L., Grant, P. S., & Nair, M. (2026). Low‐Undercooling Subzero Additive Manufacturing for Interface‐Free Biomimetic Musculoskeletal Constructs. Advanced Intelligent Systems. https://doi.org/10.1002/aisy.70620

Vancouver

Baker‐Jones SL, Grant PS, Nair M. Low‐Undercooling Subzero Additive Manufacturing for Interface‐Free Biomimetic Musculoskeletal Constructs. Advanced Intelligent Systems. 2026. doi:10.1002/aisy.70620

BibTeX
@article{BakerJones2026,
  author = {Baker‐Jones, Samantha L. and Grant, Patrick S. and Nair, Malavika},
  title = {Low‐Undercooling Subzero Additive Manufacturing for Interface‐Free Biomimetic Musculoskeletal Constructs},
  journal = {Advanced Intelligent Systems},
  year = {2026},
  doi = {10.1002/aisy.70620}
}
Kostenlos starten →