EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

One‐Shot Multimaterial 3D Printing of a Flexible Spine for a Robotic Fish Prototype

Marco Colletta, Alessio Pricci, Luca Di Leo, Gianluca Percoco

Advanced Intelligent Systems · 2026-08 · 8 (8)

DOI: 10.1002/aisy.70431 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Advanced Intelligent Systems, online erschienen am 19.05.2026. Verfasst von Marco Colletta und 3 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 32 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: MIUR.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Bioinspiration is shaping the development of next‐generation robotic systems, particularly bioinspired swimmers capable of complex locomotion in unstructured environments at minimum energetic expense. However, their development is still limited by multistep fabrication processes requiring manual assembly of compliant and stiff components. This work proposes the one‐shot multimaterial additive manufacturing (AM) of an electromagnetically (EM) actuated soft robotic fish capable of carangiform swimming, integrating polylactic acid (PLA) structural elements with a thermoplastic polyurethane (TPU) compliant spine through interlocked T‐shaped interfaces. Three TPU grades (80A, 85A, and 95A Shore hardness) are evaluated to optimize actuation performance. Among them, the TPU 85A prototype achieves the highest tail‐tip deflection while reducing the required actuation voltage (−46.67%), power consumption (−67.25%), and temperature rise (−47.68%). Finite element simulations of the soft robotic fish show good agreement with experimental bending behavior for all tested materials. Underwater tests performed across actuation frequencies from 0.5 to 5 Hz reveal a monotonic reduction in bending amplitude due to hydrodynamic load, while the mean tail‐tip oscillation speed increases with frequency, reaching a 2.85× enhancement between the lowest and highest actuation frequencies.

Förderung

  • MIUR

Zitieren

APA

Colletta, M., Pricci, A., Leo, L. D., & Percoco, G. (2026). One‐Shot Multimaterial 3D Printing of a Flexible Spine for a Robotic Fish Prototype. Advanced Intelligent Systems, 8(8). https://doi.org/10.1002/aisy.70431

Vancouver

Colletta M, Pricci A, Leo LD, Percoco G. One‐Shot Multimaterial 3D Printing of a Flexible Spine for a Robotic Fish Prototype. Advanced Intelligent Systems. 2026;8(8). doi:10.1002/aisy.70431

BibTeX
@article{Colletta2026,
  author = {Colletta, Marco and Pricci, Alessio and Leo, Luca Di and Percoco, Gianluca},
  title = {One‐Shot Multimaterial 3D Printing of a Flexible Spine for a Robotic Fish Prototype},
  journal = {Advanced Intelligent Systems},
  year = {2026},
  volume = {8},
  number = {8},
  doi = {10.1002/aisy.70431}
}
Kostenlos starten →