EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Indium Reduction in Bifacial Silicon Heterojunction Solar Cells with MoO x Hole Collector

Liqi Cao, Yifeng Zhao, Paul Procel Moya, Can Han, Katarina Kovačević, Engin Özkol, Miro Zeman, Luana Mazzarella, Olindo Isabella

Advanced Energy and Sustainability Research · 2024-09 · 5 (9)

DOI: 10.1002/aesr.202400105 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Advanced Energy and Sustainability Research, online erschienen am 20.06.2024. Verfasst von Liqi Cao und 8 weiteren Autor:innen. Die Arbeit wurde bisher 5-mal zitiert (Crossref) und nennt 48 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: China Scholarship Council.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Reducing indium consumption in transparent conductive oxide (TCO) layers is crucial for mass production of silicon heterojunction (SHJ) solar cells. In this contribution, optical simulation‐assisted design and optimization of SHJ solar cells featuring MoO x hole collectors with ultra‐thin TCO layers is performed. Firstly, bifacial SHJ solar cells with MoO x as the hole transport layer (HTL) and three types of n ‐contact as electron transport layer (ETL) are fabricated with 50 nm thick ITO on both sides. It is found that bilayer (nc‐Si:H/a‐Si:H) and trilayer (nc‐SiO x :H/nc‐Si:H/a‐Si:H) as n ‐contacts performed electronically and optically better than monolayer (a‐Si:H) in bifacial SHJ cells, respectively. Then, as suggested by optical simulations, the same stack of tungsten‐doped indium oxide (IWO) and optimized MgF 2 layers are applied on both sides of front/back‐contacted SHJ solar cells. Devices endowed with 10 nm thick IWO and bilayer n ‐contact exhibit a certified efficiency of 21.66% and 20.66% when measured from MoO x and n ‐contact side, respectively. Specifically, when illuminating from the MoO x side, the short‐circuit current density and the fill factor remain well above 40 mA cm −2 and 77%, respectively. Compared to standard front/rear TCO thicknesses (75 nm/150 nm) deployed in monofacial SHJ solar cells, this represents over 90% TCO reduction. As for bifacial cells featuring 50 nm thick IWO layers, a champion device with a bilayer n ‐contact as ETL is obtained, which exhibits certified conversion efficiency of 23.25% and 22.75% when characterized from the MoO x side and the n ‐layer side, respectively, with a bifaciality factor of 0.98. In general, by utilizing a n ‐type bilayer stack, bifaciality factor is above 0.96 and it can be further enhanced up to 0.99 by switching to a n ‐type trilayer stack. Again, compared to the aforementioned standard front/rear TCO thicknesses, this translates to a TCO reduction of more than 67%.

Förderung

  • China Scholarship Council

Zitieren

APA

Cao, L., Zhao, Y., Moya, P. P., Han, C., Kovačević, K., Özkol, E., Zeman, M., Mazzarella, L., & Isabella, O. (2024). Indium Reduction in Bifacial Silicon Heterojunction Solar Cells with MoO x Hole Collector. Advanced Energy and Sustainability Research, 5(9). https://doi.org/10.1002/aesr.202400105

Vancouver

Cao L, Zhao Y, Moya PP, Han C, Kovačević K, Özkol E, et al. Indium Reduction in Bifacial Silicon Heterojunction Solar Cells with MoO x Hole Collector. Advanced Energy and Sustainability Research. 2024;5(9). doi:10.1002/aesr.202400105

BibTeX
@article{Cao2024,
  author = {Cao, Liqi and Zhao, Yifeng and Moya, Paul Procel and Han, Can and Kovačević, Katarina and Özkol, Engin and Zeman, Miro and Mazzarella, Luana and Isabella, Olindo},
  title = {Indium Reduction in Bifacial Silicon Heterojunction Solar Cells with MoO x Hole Collector},
  journal = {Advanced Energy and Sustainability Research},
  year = {2024},
  volume = {5},
  number = {9},
  doi = {10.1002/aesr.202400105}
}
Kostenlos starten →