Cathode Upcycling for Direct Recycling of Lithium‐Ion Batteries Using a Precipitation Approach
Advanced Energy Materials · 2025-12 · 15 (46)
DOI: 10.1002/aenm.202500699 ↗Kurz gefasst
Fachartikel in der Zeitschrift Advanced Energy Materials, online erschienen am 27.05.2025. Verfasst von Eva Allen und 13 weiteren Autor:innen. Die Arbeit wurde bisher 15-mal zitiert (Crossref) und nennt 26 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC 4.0). Gefördert von: Office of Energy Efficiency and Renewable Energy, U.S. Department of Energy.
Abstract (Originalsprache)
With the increased production of electric vehicles to reduce carbon emissions, the lithium‐ion battery market to supply those vehicles has grown dramatically. To enhance battery sustainability and circularity, direct recycling methods aim to recover intact cathode materials. However, end‐of‐life cathode materials are typically 15–20 years old and often have lower energy density compared to current cathode materials. To address this challenge, a rapid precipitation process is developed to boost energy density by converting low Ni‐compositions, LiNi 0.33 Co 0.33 Mn 0.33 O 2 (NMC111), into higher Ni‐compositions (NMC622). This process forms a Ni‐rich coating on cathode particles that diffuses into the core upon high‐temperature relithiation, increasing compositional homogeneity. The upcycling process leverages existing infrastructure, offering low capital cost and minimal additional chemical input. Through ex situ tomographic transmission X‐ray microscopy (TXM), 3D Ni:Co elemental mixing is quantified, confirming that elemental content evens at the secondary particle level with a mean NMC622 composition upon relithiation. However, elemental gradients remain in the single crystalline primary particles. Ex situ high‐resolution and in situ wide‐angle X‐ray diffraction reveals concurrent structural changes during the relithiation process. These findings provide key insights into the structural and chemical mechanisms of elemental diffusion to obtain further improvements of increased capacity and retention through compositional conversion of cathode materials.
Förderung
- Office of Energy Efficiency and Renewable Energy
- U.S. Department of Energy
Zitieren
APA
Allen, E., Macholz, J., Nisbet, M., Chowdhury, N., Wang, F., Porwal, M., Keane, D. T., Guise, W., Dundek, Z., Caple, M., Nikitin, V., Cabana, J., Dai, Q., & Lipson, A. (2025). Cathode Upcycling for Direct Recycling of Lithium‐Ion Batteries Using a Precipitation Approach. Advanced Energy Materials, 15(46). https://doi.org/10.1002/aenm.202500699
Vancouver
Allen E, Macholz J, Nisbet M, Chowdhury N, Wang F, Porwal M, et al. Cathode Upcycling for Direct Recycling of Lithium‐Ion Batteries Using a Precipitation Approach. Advanced Energy Materials. 2025;15(46). doi:10.1002/aenm.202500699
BibTeX
@article{Allen2025,
author = {Allen, Eva and Macholz, Jessica and Nisbet, Matthew and Chowdhury, Nighat and Wang, Feng and Porwal, Mansi and Keane, Denis T. and Guise, William and Dundek, Zachary and Caple, Michael and Nikitin, Viktor and Cabana, Jordi and Dai, Qiang and Lipson, Albert},
title = {Cathode Upcycling for Direct Recycling of Lithium‐Ion Batteries Using a Precipitation Approach},
journal = {Advanced Energy Materials},
year = {2025},
volume = {15},
number = {46},
doi = {10.1002/aenm.202500699}
}
EUVIMED