EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Enhanced Bandgap Flexibility in Perovskite‐Silicon Tandem Solar Cells via Three‐Terminal Architecture

Mohammad Gholipoor, Michael Rienaecker, Xuzheng Liu, Seyedamir Orooji, Lingyi Fang, Paul Fassl, Renjun Guo iD, Uli Lemmer, Robby Peibst, Ulrich Wilhelm Paetzold

Advanced Science · 2026-03 · 13 (18)

DOI: 10.1002/advs.202520603 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Advanced Science, online erschienen am 29.01.2026. Verfasst von Mohammad Gholipoor und 9 weiteren Autor:innen. Beteiligte Einrichtung: Light Technology Institute (LTI), Karlsruhe Institute of Technology (KIT), Karlsruhe, Germany. Die Arbeit wurde bisher 8-mal zitiert (Crossref) und nennt 55 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Monolithic perovskite/silicon tandem photovoltaics are among the most promising high‐efficiency technologies for next‐generation photovoltaics. However, the commercial development of two‐terminal (2T) tandem configurations is limited by their operational instability of wide‐bandgap perovskite materials, which leads to current mismatch and increased sensitivity to solar spectral variations. Three‐terminal (3T) tandem architectures offer a viable route to address these limitations. Here, we demonstrate the real‐world advantages of 3T perovskite/silicon tandem solar cells in mitigating current mismatch limitations and losses arising from solar spectral variations. Our 3T tandem solar cells achieve a power conversion efficiency of 30.1%, integrating a front‐side textured interdigitated back contact (IBC) and poly‐Si on oxide contact (POLO) silicon bottom cell. This is one of the highest efficiencies reported for 3T tandem solar cells so far. Through a direct comparison of 2T and 3T tandem configurations enabled by a novel measurement framework, we reveal that 3T architectures decouple performance from perovskite bandgap constraints, alleviating the need for the current matching. Additionally, 3T tandem solar cells exhibit enhanced spectral resilience under varying solar spectra when the top cell limits the short‐circuit current. These findings underscore the potential of 3T architectures for stable and efficient tandem photovoltaics under real‐world operating conditions.

Schlagwörter

Stichwörter der Autor:innen

POLOperovskitephotovoltaicstandem solar cellsthree terminal

Autor:innen und Institutionen

  • Light Technology Institute (LTI), Karlsruhe Institute of Technology (KIT), Karlsruhe, Germany.
  • Institute of Microstructure Technology (IMT), Karlsruhe Institute of Technology (KIT), Eggenstein-Leopoldshafen, Germany.
  • Institute for Electronic Materials and Devices, Leibniz University Hannover, Hannover, Germany.
  • Institute for Solar Energy Research Hamelin (ISFH), Emmerthal, Germany.

ORCID-Profile: Renjun Guo

Zitieren

APA

Gholipoor, M., Rienaecker, M., Liu, X., Orooji, S., Fang, L., Fassl, P., Guo, R., Lemmer, U., Peibst, R., & Paetzold, U. W. (2026). Enhanced Bandgap Flexibility in Perovskite‐Silicon Tandem Solar Cells via Three‐Terminal Architecture. Advanced Science, 13(18). https://doi.org/10.1002/advs.202520603

Vancouver

Gholipoor M, Rienaecker M, Liu X, Orooji S, Fang L, Fassl P, et al. Enhanced Bandgap Flexibility in Perovskite‐Silicon Tandem Solar Cells via Three‐Terminal Architecture. Advanced Science. 2026;13(18). doi:10.1002/advs.202520603

BibTeX
@article{Gholipoor2026,
  author = {Gholipoor, Mohammad and Rienaecker, Michael and Liu, Xuzheng and Orooji, Seyedamir and Fang, Lingyi and Fassl, Paul and Guo, Renjun and Lemmer, Uli and Peibst, Robby and Paetzold, Ulrich Wilhelm},
  title = {Enhanced Bandgap Flexibility in Perovskite‐Silicon Tandem Solar Cells via Three‐Terminal Architecture},
  journal = {Advanced Science},
  year = {2026},
  volume = {13},
  number = {18},
  doi = {10.1002/advs.202520603}
}
Kostenlos starten →