EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

High‐Humidity‐Tolerant Chloride Solid‐State Electrolyte for All‐Solid‐State Lithium Batteries

Kai Wang iD, Zhenqi Gu, Haoxuan Liu, Lv Hu, Ying Wu, Jie Xu iD, Cheng Ma

Advanced Science · 2024-04 · 11 (14)

DOI: 10.1002/advs.202305394 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Advanced Science, online erschienen am 02.02.2024. Verfasst von Kai Wang und 6 weiteren Autor:innen. Beteiligte Einrichtung: School of Materials & Energy, Lanzhou University, Lanzhou, Gansu, 730000, China. Die Arbeit wurde bisher 42-mal zitiert (Crossref) und nennt 37 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Strategic Priority Research Program of the Chinese Academy of Sciences, USTC Research Funds of the Double First-Class Initiative, Scientific Research Start-up Funds of Lanzhou University.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Halide solid‐state electrolytes (SSEs) hold promise for the commercialization of all‐solid‐state lithium batteries (ASSLBs); however, the currently cost‐effective zirconium‐based chloride SSEs suffer from hygroscopic irreversibility, low ionic conductivity, and inadequate thermal stability. Herein, a novel indium‐doped zirconium‐based chloride is fabricated to satisfy the abovementioned requirements, achieving outstanding‐performance ASSLBs at room temperature. Compared to the conventional Li 2 ZrCl 6 and Li 3 InCl 6 SSEs, the hc‐Li 2+x Zr 1‐x In x Cl 6 (0.3 ≤ x ≤ 1) possesses higher ionic conductivity (up to 1.4 mS cm −1 ), and thermal stability (350 °C). At the same time, the hc‐Li 2.8 Zr 0.2 In 0.8 Cl 6 also shows obvious hygroscopic reversibility, where its recovery rate of the ionic conductivity is up to 82.5% after 24‐h exposure in the 5% relative humidity followed by heat treatment. Theoretical calculation and experimental results reveal that those advantages are derived from the lattice expansion and the formation of Li 3 InCl 6 ·2H 2 O hydrates, which can effectively reduce the migration energy barrier of Li ions and offer reversible hydration/dehydration pathway. Finally, an ASSLB, assembled with reheated‐Li 2.8 Zr 0.2 In 0.8 Cl 6 after humidity exposure, single‐crystal LiNi 0.8 Mn 0.1 Co 0.1 O 2 and Li‐In alloy, exhibits capacity retention of 71% after 500 cycles under 1 C at 25 °C. This novel high‐humidity‐tolerant chloride electrolyte is expected to greatly carry forward the ASSLBs industrialization.

Schlagwörter

Stichwörter der Autor:innen

aliovalent substitutionall‐solid‐state lithium batterieschloride solid‐state electrolyteshumidity tolerance

Autor:innen und Institutionen

  • School of Materials & Energy, Lanzhou University, Lanzhou, Gansu, 730000, China.
  • Hefei National Research Center for Physical Sciences at the Microscale, CAS Key Laboratory of Materials for Energy Conversion, Department of Materials Science and Engineering, University of Science and Technology of Chi…
  • Institute for Superconducting and Electronic Materials, Australian Institute for Innovative Materials, University of Wollongong, Wollongong, New South Wales, 2525, Australia.
  • College of Chemistry and Materials Engineering, Wenzhou University, Wenzhou, Zhejiang, 325035, China.
  • National Synchrotron Radiation Laboratory, Hefei, Anhui, 230026, China.

ORCID-Profile: Kai Wang, Jie Xu

Förderung

  • Strategic Priority Research Program of the Chinese Academy of Sciences
  • USTC Research Funds of the Double First-Class Initiative
  • Scientific Research Start-up Funds of Lanzhou University
  • National Natural Science Foundation of China
  • National Key Research and Development Program of China
  • Fundamental Research Funds for the Central Universities
  • National Synchrotron Radiation Laboratory

Zitieren

APA

Wang, K., Gu, Z., Liu, H., Hu, L., Wu, Y., Xu, J., & Ma, C. (2024). High‐Humidity‐Tolerant Chloride Solid‐State Electrolyte for All‐Solid‐State Lithium Batteries. Advanced Science, 11(14). https://doi.org/10.1002/advs.202305394

Vancouver

Wang K, Gu Z, Liu H, Hu L, Wu Y, Xu J, et al. High‐Humidity‐Tolerant Chloride Solid‐State Electrolyte for All‐Solid‐State Lithium Batteries. Advanced Science. 2024;11(14). doi:10.1002/advs.202305394

BibTeX
@article{Wang2024,
  author = {Wang, Kai and Gu, Zhenqi and Liu, Haoxuan and Hu, Lv and Wu, Ying and Xu, Jie and Ma, Cheng},
  title = {High‐Humidity‐Tolerant Chloride Solid‐State Electrolyte for All‐Solid‐State Lithium Batteries},
  journal = {Advanced Science},
  year = {2024},
  volume = {11},
  number = {14},
  doi = {10.1002/advs.202305394}
}
Kostenlos starten →