EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC-ND 4.0

Interfacial Engineering of ZIF‐67@Ti 3 C 2 T x MXene Hybrids for Selective Electrochemical CO 2 Reduction to C 1 Products

Fateme Sadat Hojati, Shaylin Abdinejad, Hamid Reza Godini, Mohammad Ali Kiani, Maryam Abdinejad, Azam Akabri

Advanced Sustainable Systems · 2026-04 · 10 (4)

DOI: 10.1002/adsu.70470 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Advanced Sustainable Systems, online erschienen am 22.04.2026. Verfasst von Fateme Sadat Hojati und 5 weiteren Autor:innen. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 62 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Electrochemical CO 2 reduction (CO 2 RR) enables conversion of CO 2 into fuel‐relevant products using renewable electricity, but aqueous systems are often limited by hydrogen evolution reaction (HER) and mass‐transport constraints. Here, a ZIF‐67@Ti 3 C 2 T x MXene hybrid electrocatalyst is prepared via in situ growth of cobalt‐based ZIF‐67 nanoparticles on conductive Ti 3 C 2 T x sheets synthesized using a mild LiF/HCl etching route. The catalytic performance is systematically evaluated in both H‐cell and gas‐fed flow‐cell configurations. Among the investigated compositions (15, 30, and 45 wt.%), ZIF(30%)@Ti 3 C 2 T x provides the most favorable balance between conductivity and accessible catalytic site density. Under gas‐fed flow‐cell operation, ZIF(30%)@Ti 3 C 2 T x reaches its highest CO 2 RR selectivity at −0.8 V vs RHE, delivering ∼84% total Faradaic efficiency toward carbon‐containing products (dominated by methane and methanol) while maintaining stable performance over 10 h of continuous electrolysis. In comparison, ZIF‐67 requires a more negative potential to reach its best performance and exhibits lower carbon‐product selectivity due to stronger competition from HER. These results highlight how MOF–MXene interfacial engineering, together with a flow‐cell configuration, can improve charge transport and active‐site utilization to enhance aqueous CO 2 electroreduction selectivity and stability.

Zitieren

APA

Hojati, F. S., Abdinejad, S., Godini, H. R., Kiani, M. A., Abdinejad, M., & Akabri, A. (2026). Interfacial Engineering of ZIF‐67@Ti 3 C 2 T x MXene Hybrids for Selective Electrochemical CO 2 Reduction to C 1 Products. Advanced Sustainable Systems, 10(4). https://doi.org/10.1002/adsu.70470

Vancouver

Hojati FS, Abdinejad S, Godini HR, Kiani MA, Abdinejad M, Akabri A. Interfacial Engineering of ZIF‐67@Ti 3 C 2 T x MXene Hybrids for Selective Electrochemical CO 2 Reduction to C 1 Products. Advanced Sustainable Systems. 2026;10(4). doi:10.1002/adsu.70470

BibTeX
@article{Hojati2026,
  author = {Hojati, Fateme Sadat and Abdinejad, Shaylin and Godini, Hamid Reza and Kiani, Mohammad Ali and Abdinejad, Maryam and Akabri, Azam},
  title = {Interfacial Engineering of ZIF‐67@Ti 3 C 2 T x MXene Hybrids for Selective Electrochemical CO 2 Reduction to C 1 Products},
  journal = {Advanced Sustainable Systems},
  year = {2026},
  volume = {10},
  number = {4},
  doi = {10.1002/adsu.70470}
}
Kostenlos starten →