A Microstructured‐Enhanced Flexible Sensor With Integrated Sensing and Adhesion for UAV Status Monitoring
Advanced Materials Technologies · 2026-11 · 11 (21)
DOI: 10.1002/admt.202502346 ↗Kurz gefasst
Fachartikel in der Zeitschrift Advanced Materials Technologies, online erschienen am 24.01.2026. Verfasst von Qiyun Zhong und 9 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 43 Literaturangaben.
Abstract (Originalsprache)
Flexible sensors are pivotal to advancements in intelligent robotics, health monitoring, and aerospace. Conventional sensors struggle to balance wide‐range detection and integrated adhesion, so this study proposes a microstructure‐enhanced polyvinyl chloride/multi‐walled carbon nanotubes (MWCNTs) polymer gel (MPG) sensor. It achieves integrated sensing and adhesion by fabricating a microcolumn array with a diameter of 20 µm and a height of 60 µm. The microstructures boost interfacial adhesion up to 301 mN/cm 2 via increased contact area and convert mechanical deformation into electrical signals efficiently for pressure sensing using high aspect ratio. At 0.4 wt% MWCNTs content, the sensor shows optimal performance. It delivers an output voltage of 4.7 V under 100 kPa and a response time of 173 ms. Even at 0.2 wt% MWCNTs content, it maintains stable output after 600 compression cycles, with a mechanical recovery rate of ≥96% and excellent thermal stability. Its effectiveness and application potential in complex scenarios are verified by micro‐UAV negative‐surface adhesion landing tests and dynamic wing data acquisition of fixed‐wing UAVs throughout taxiing, takeoff, cruising, and landing. This research provides new solutions for flexible electronics, intelligent robotics, and aerospace structural health monitoring.
Zitieren
APA
Zhong, Q., Li, Y., Liu, D., Lu, X., Liu, S., Ye, Y., Zhan, F., He, C., Xu, X., & He, Q. (2026). A Microstructured‐Enhanced Flexible Sensor With Integrated Sensing and Adhesion for UAV Status Monitoring. Advanced Materials Technologies, 11(21). https://doi.org/10.1002/admt.202502346
Vancouver
Zhong Q, Li Y, Liu D, Lu X, Liu S, Ye Y, et al. A Microstructured‐Enhanced Flexible Sensor With Integrated Sensing and Adhesion for UAV Status Monitoring. Advanced Materials Technologies. 2026;11(21). doi:10.1002/admt.202502346
BibTeX
@article{Zhong2026,
author = {Zhong, Qiyun and Li, Yangyang and Liu, Diyi and Lu, Xinyu and Liu, Siyuan and Ye, Yuze and Zhan, Fengjiang and He, Cheng and Xu, Xiaodong and He, Qingsong},
title = {A Microstructured‐Enhanced Flexible Sensor With Integrated Sensing and Adhesion for UAV Status Monitoring},
journal = {Advanced Materials Technologies},
year = {2026},
volume = {11},
number = {21},
doi = {10.1002/admt.202502346}
}
EUVIMED