EUVIMEDEUVIMED entdecken
Crossref

Quasi‐2D Morphologies of a Non‐Fullerene Acceptor Y6 by Interfacial Assembly via Langmuir–Schaefer Technique

Yisak Tsegazab Gerase iD, Anna Elmanova, Sarah Jasmin Finkelmeyer, Andrea Dellith, Jan Dellith, Julien Guthmuller, Oleg Ryabchykov, Thomas Bocklitz, Filippo Giovanni Fabozzi, Nikolai Severin, Stefan Hecht, Lukas Renn und 5 weitere

Advanced Materials · 2026-01 · 38 (6)

DOI: 10.1002/adma.202509825 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Advanced Materials, online erschienen am 10.11.2025. Verfasst von Yisak Tsegazab Gerase und 16 weiteren Autor:innen. Beteiligte Einrichtung: Institute of Physical Chemistry, Friedrich Schiller University Jena, Helmholtzweg 4, 07743, Jena, Germany. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 90 Literaturangaben. Gefördert von: Deutscher Akademischer Austauschdienst, Deutsche Forschungsgemeinschaft.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Supramolecular organization governs the structure and optoelectronic properties of organic thin films. This study shows that films based on the non‐fullerene acceptor Y6 can be precisely structured via assembly at the air‐water interface. Theoretical cross‐sectional areas, Langmuir isotherms, and Brewster angle microscopy reveal that Y6, despite its complex structure, is sufficiently amphiphilic to form well‐defined 2D layers. Mechanical annealing through repeated compression‐expansion cycles systematically improves structural uniformity, as evidenced by narrower in situ detected fluorescence spectra, while simultaneously shifting the maximum of the compressional modulus toward denser packing. Compared to spin‐cast films, Langmuir–Schaefer (LS) layers exhibit a significantly reduced Stokes shift, suggesting less reorganization after photoexcitation and thus a higher supramolecular order. Organic thin‐film transistors (OTFTs) fabricated using the LS technique achieve mobilities comparable to those of spin‐cast films, despite being substantially thinner (≤ 3 nm, determined by atomic force microscopy), thus requiring considerably less material. Notably, Y6‐LS OTFTs outperform previously reported polymer‐based LS‐OTFTs by one order of magnitude in charge carrier mobility. This work highlights the potential of interfacial assembly for thin film fabrication and underscores the advantages of mechanical annealing and in situ spectroscopy to enhance the performance of organic optoelectronic devices.

Schlagwörter

Stichwörter der Autor:innen

langmuir layersmorphologynon‐fullerene acceptoroptoelectronicsultrathin film

Autor:innen und Institutionen

  • Institute of Physical Chemistry, Friedrich Schiller University Jena, Helmholtzweg 4, 07743, Jena, Germany.
  • Leibniz Institute of Photonic Technology (IPHT), Albert-Einstein-Str. 9, 07745, Jena, Germany.
  • Sciclus GmbH & Co. KG, Moritz-von-Rohr-Str. 1a, 07745, Jena, Germany.
  • Institute of Physics and Applied Computer Science, Faculty of Applied Physics and Mathematics, Gdańsk University of Technology, Narutowicza 11/12, Gdańsk, 80233, Poland.
  • Department of Chemistry and Center for the Science of Materials Berlin, Humboldt-Universität zu Berlin, 12489, Berlin, Germany.
  • Department of Physics and Center for the Science of Materials Berlin, Humboldt-Universität zu Berlin, 12489, Berlin, Germany.

ORCID-Profile: Yisak Tsegazab Gerase, Martin Presselt

Förderung

  • Deutscher Akademischer Austauschdienst
  • Deutsche Forschungsgemeinschaft

Zitieren

APA

Gerase, Y. T., Elmanova, A., Finkelmeyer, S. J., Dellith, A., Dellith, J., Guthmuller, J., Ryabchykov, O., Bocklitz, T., Fabozzi, F. G., Severin, N., Hecht, S., Renn, L., Borchert, J., Weitz, R. T., Müller, J., Koch, C. T., & Presselt, M. (2026). Quasi‐2D Morphologies of a Non‐Fullerene Acceptor Y6 by Interfacial Assembly via Langmuir–Schaefer Technique. Advanced Materials, 38(6). https://doi.org/10.1002/adma.202509825

Vancouver

Gerase YT, Elmanova A, Finkelmeyer SJ, Dellith A, Dellith J, Guthmuller J, et al. Quasi‐2D Morphologies of a Non‐Fullerene Acceptor Y6 by Interfacial Assembly via Langmuir–Schaefer Technique. Advanced Materials. 2026;38(6). doi:10.1002/adma.202509825

BibTeX
@article{Gerase2026,
  author = {Gerase, Yisak Tsegazab and Elmanova, Anna and Finkelmeyer, Sarah Jasmin and Dellith, Andrea and Dellith, Jan and Guthmuller, Julien and Ryabchykov, Oleg and Bocklitz, Thomas and Fabozzi, Filippo Giovanni and Severin, Nikolai and Hecht, Stefan and Renn, Lukas and Borchert, James and Weitz, R Thomas and Müller, Johannes and Koch, Christoph T and Presselt, Martin},
  title = {Quasi‐2D Morphologies of a Non‐Fullerene Acceptor Y6 by Interfacial Assembly via Langmuir–Schaefer Technique},
  journal = {Advanced Materials},
  year = {2026},
  volume = {38},
  number = {6},
  doi = {10.1002/adma.202509825}
}
Kostenlos starten →