Micro‐Strain Responsive Near‐Infrared Mechanoluminescence for Potential Nondestructive Artificial Joint Stress Imaging
Advanced Materials · 2026-01 · 38 (1)
DOI: 10.1002/adma.202505360 ↗Kurz gefasst
Fachartikel in der Zeitschrift Advanced Materials, online erschienen am 08.09.2025. Verfasst von Wenhao Li und 9 weiteren Autor:innen. Beteiligte Einrichtung: Key Laboratory of In-Fiber Integrated Optics of Ministry of Education, College of Physics and Optoelectronic Engineering, Harbin Engineering Universi…. Hauptthemen laut MEDLINE: Stress, Mechanical, Infrared Rays, Luminescent Measurements, Joint Prosthesis. Die Arbeit wurde bisher 23-mal zitiert (Crossref) und nennt 66 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Natural Science Foundation of China, Guangdong Basic and Applied Basic Research Foundation, Natural Science Foundation of Heilongjiang Province of China.
Abstract (Originalsprache)
Recently, joint replacement surgery is facing significant challenges of patient dissatisfaction and the need for revision procedures. In‐situ monitoring of stress stability at the site of artificial joint replacement during postoperative evaluation is important. Mechanoluminescence (ML), a novel “force to light” conversion technology, may be used to monitor such bio‐stress within tissues. However, this is hindered by ultraviolet–visible ML emission wavelength, low ML intensity, and high strain response sensitivity. Here, by incorporating Sb 3+ ions into Sr 3 Sn 2 O 7 crystals, a highly strain‐responsive material, with ML originating from intrinsic defect emissions is obtained. The Sr 3 Sn 1.98 Sb 0.02 O 6.99 film produces detectable ML signals under compressive strain as low as 50 µst in the absence of biological tissue. After pre‐irradiating with red light through 15 mm of porcine tissue, ML signals can still be detected through the same tissue thickness. Notably, this material enabled real‐time stress imaging through 4 mm of porcine skin during mild finger joint bending. This work presents a novel methodological framework and proposes a new mechanism to defect ML. It offers a fresh perspective for designing high‐performance ML materials and lays the foundation for innovative research to enhance the functionality of artificial tissues and joints in living organism.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Substanzen
Autor:innen und Institutionen
- Key Laboratory of In-Fiber Integrated Optics of Ministry of Education, College of Physics and Optoelectronic Engineering, Harbin Engineering University, Harbin, 150001, China.
- Department of Electrical and Electronic Engineering, The University of Hong Kong, Hong Kong, 999077, China.
- Macau Institute of Materials Science and Engineering (MIMSE), Macau University of Science and Technology, Taipa, Macao, 999078, China.
- College of Nuclear Science and Technology, Harbin Engineering University, Harbin, 150001, China.
- PSL Research University Chimie Paris Tech IRCP, CNRS, Paris, 75005, France.
- Faculty of Applied Sciences, Department of Radiation Science and Technology, Delft University of Technology, Mekelweg 15, Delft, 2629JB, The Netherlands.
ORCID-Profile: Puxian Xiong
Förderung
- National Natural Science Foundation of China
- Guangdong Basic and Applied Basic Research Foundation
- Natural Science Foundation of Heilongjiang Province of China
- Basic and Applied Basic Research Foundation of Guangdong Province
Zitieren
APA
Li, W., Xiong, P., Zheng, X., Niu, L., Cui, L., Wang, Q., Viana, B., Dorenbos, P., Zhang, J., & Ren, J. (2026). Micro‐Strain Responsive Near‐Infrared Mechanoluminescence for Potential Nondestructive Artificial Joint Stress Imaging. Advanced Materials, 38(1). https://doi.org/10.1002/adma.202505360
Vancouver
Li W, Xiong P, Zheng X, Niu L, Cui L, Wang Q, et al. Micro‐Strain Responsive Near‐Infrared Mechanoluminescence for Potential Nondestructive Artificial Joint Stress Imaging. Advanced Materials. 2026;38(1). doi:10.1002/adma.202505360
BibTeX
@article{Li2026,
author = {Li, Wenhao and Xiong, Puxian and Zheng, Xiaoxin and Niu, Luyue and Cui, Lugui and Wang, Qingyu and Viana, Bruno and Dorenbos, Pieter and Zhang, Jianzhong and Ren, Jing},
title = {Micro‐Strain Responsive Near‐Infrared Mechanoluminescence for Potential Nondestructive Artificial Joint Stress Imaging},
journal = {Advanced Materials},
year = {2026},
volume = {38},
number = {1},
doi = {10.1002/adma.202505360}
}
EUVIMED