EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC 4.0

Revisiting the “Stick‐Slip” Process via Magnetism‐Coupled Flexible Sensors with Bioinspired Ridge Architecture

Dan Fang, Sen Ding, Yuhan Liu, Qian Zhou, Biao Qi, Bing Ji, Bingpu Zhou iD

Advanced Materials · 2025-05 · 37 (19)

DOI: 10.1002/adma.202417867 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Advanced Materials, online erschienen am 19.03.2025. Verfasst von Dan Fang und 6 weiteren Autor:innen. Beteiligte Einrichtung: Joint Key Laboratory of the Ministry of Education, Institute of Applied Physics and Materials Engineering, University of Macau, Avenida da Universida…. Die Arbeit wurde bisher 21-mal zitiert (Crossref) und nennt 39 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC 4.0). Gefördert von: Science and Technology Development Fund, Macau SAR, University of Macau, Guangdong Provincial Department of Science and Technology.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

“Stick‐slip” phenomenon that occurs when human fingertip scans across a specific surface is essential to perceive the interactions between skin and the surface. Understanding the “stick‐slip” behavior is important for bionic flexible system in applications from advanced robotics to intelligent tactile sensors. However, it is often overlooked owing to the limitations to mimic the soft skin that can tangentially deform/recover with informative electrical feedback. Here, a sandwich‐type device with deformable ridge‐layer is proposed to analyze the characteristic of stick/slip states in “stick‐slip” process. Specifically, it is observed that fast recovery of the sensing architecture is caused by dynamic slip phase that generates periodical signals based on principle of induction. The results experimentally show that periods of the electrical pulses are dependent on factors such as inherent properties (e.g., modulus and geometry) and operational parameters (e.g., scanning speed and normal load), which is consistent with the theoretical model. Furthermore, it is found that the transition between “stick‐slip” and full slip could qualitatively reflect interfacial properties such as moisture, roughness, and topology. It is expected that the results can strengthen the understanding of “stick‐slip” behavior when fingertip interacts with a surface and provide guidance of flexible sensor design to enrich the biomimetic perceptions.

Schlagwörter

Stichwörter der Autor:innen

flexible sensorsmagnetized devicesslip phasestick‐sliptactile perceptions

Autor:innen und Institutionen

  • Joint Key Laboratory of the Ministry of Education, Institute of Applied Physics and Materials Engineering, University of Macau, Avenida da Universidade, Taipa, Macau, 999078, China.
  • School of Physics, Central South University, Changsha, 410083, China.
  • School of Physics and Electronics, Hunan Normal University, Changsha, 410081, China.
  • Department of Physics and Chemistry, Faculty of Science and Technology, University of Macau, Avenida da Universidade, Taipa, Macau, 999078, China.

ORCID-Profile: Bingpu Zhou

Förderung

  • Science and Technology Development Fund, Macau SAR
  • University of Macau
  • Guangdong Provincial Department of Science and Technology
  • Universidade de Macau

Zitieren

APA

Fang, D., Ding, S., Liu, Y., Zhou, Q., Qi, B., Ji, B., & Zhou, B. (2025). Revisiting the “Stick‐Slip” Process via Magnetism‐Coupled Flexible Sensors with Bioinspired Ridge Architecture. Advanced Materials, 37(19). https://doi.org/10.1002/adma.202417867

Vancouver

Fang D, Ding S, Liu Y, Zhou Q, Qi B, Ji B, et al. Revisiting the “Stick‐Slip” Process via Magnetism‐Coupled Flexible Sensors with Bioinspired Ridge Architecture. Advanced Materials. 2025;37(19). doi:10.1002/adma.202417867

BibTeX
@article{Fang2025,
  author = {Fang, Dan and Ding, Sen and Liu, Yuhan and Zhou, Qian and Qi, Biao and Ji, Bing and Zhou, Bingpu},
  title = {Revisiting the “Stick‐Slip” Process via Magnetism‐Coupled Flexible Sensors with Bioinspired Ridge Architecture},
  journal = {Advanced Materials},
  year = {2025},
  volume = {37},
  number = {19},
  doi = {10.1002/adma.202417867}
}
Kostenlos starten →