In Situ Conversion of Artificial Proton‐Rich Shell to Inorganic Maskant Toward Stable Single‐Crystal Ni‐Rich Cathode
Advanced Materials · 2025-02 · 37 (7)
DOI: 10.1002/adma.202415860 ↗Kurz gefasst
Fachartikel in der Zeitschrift Advanced Materials, online erschienen am 26.12.2024. Verfasst von Haoyu Xue und 11 weiteren Autor:innen. Beteiligte Einrichtung: School of Advanced Materials, Peking University Shenzhen Graduate School, Shenzhen, 518055, China. Die Arbeit wurde bisher 38-mal zitiert (Crossref) und nennt 50 Literaturangaben. Gefördert von: Basic and Applied Basic Research Foundation of Guangdong Province, International joint Research Center for Electric Vehicle Power Battery and Materials, Guangdong Key Laboratory of Design and calculation of New Energy Materials.
Abstract (Originalsprache)
Single‐crystal high‐nickel oxide with an integral structure can prevent intergranular cracks and the associated detrimental reactions. Yet, its low surface‐to‐volume ratio makes surficial degradation a more critical factor in electrochemical performance. Herein, artificial proton‐rich (ammonium bicarbonate) shell is successfully introduced on the nickel‐rich LiNi 0.92 Co 0.06 Mn 0.02 O 2 single crystals for in situ electrochemically conversing into inorganic maskant to enhance stability of cathode. The process is that the surficial enriched proton, once released from the ammonium bicarbonate shell (proton reservoir) during 1st charge, is immediately captured by LiPF 6 , in situ electrochemically conversing to LiF and Li 3 PO 4 sub‐nano particle dense maskant (sub‐nano F‐&P‐maskant). The in situ formed compact nano F‐&P‐maskant significantly resists the cathode against electrolyte attack and improves the surface stability of particles during long‐term cycling. Consequently, this surface modification enables 95% capacity retention after 100 cycles at a high voltage of 4.5 V in the half cell and 83% capacity retention after 800 cycles in the full cell. This work demonstrates a strategy for reconstructing the protective layer using the rational design of surficial enriched proton shells for advanced lithium batteries.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- School of Advanced Materials, Peking University Shenzhen Graduate School, Shenzhen, 518055, China.
- Department of Chemistry, The University of Hong Kong, Hong Kong, 999077, China.
- School of Materials, Sun Yat-sen University, Shenzhen, 518107, China.
- School of Science and Engineering, The Chinese University of Hong Kong, Shenzhen, 518172, China.
- Chemical Sciences and Engineering Division, Argonne National Laboratory, Lemont, IL, 60439, USA.
- Shenyang National Laboratory for Materials Science, Institute of Metal Research, Chinese Academy of Sciences, Shenyang, 110016, China.
ORCID-Profile: Feng Pan
Förderung
- Basic and Applied Basic Research Foundation of Guangdong Province
- International joint Research Center for Electric Vehicle Power Battery and Materials
- Guangdong Key Laboratory of Design and calculation of New Energy Materials
- Shenzhen Key Laboratory of New Energy Resources Genome Preparation and Testing
- Liaoning Provincial Science Fund for Distinguished Young Scholar
Zitieren
APA
Xue, H., Liang, Y., Huang, Y., Ji, Y., Xu, Z., Chen, X., Wang, H., Liu, J., Amine, K., Liu, T., Tan, X., & Pan, F. (2025). In Situ Conversion of Artificial Proton‐Rich Shell to Inorganic Maskant Toward Stable Single‐Crystal Ni‐Rich Cathode. Advanced Materials, 37(7). https://doi.org/10.1002/adma.202415860
Vancouver
Xue H, Liang Y, Huang Y, Ji Y, Xu Z, Chen X, et al. In Situ Conversion of Artificial Proton‐Rich Shell to Inorganic Maskant Toward Stable Single‐Crystal Ni‐Rich Cathode. Advanced Materials. 2025;37(7). doi:10.1002/adma.202415860
BibTeX
@article{Xue2025,
author = {Xue, Haoyu and Liang, Yongzhi and Huang, Yuxiang and Ji, Yuchen and Xu, Zhongxing and Chen, Xinhan and Wang, Honghao and Liu, Jiajie and Amine, Khalil and Liu, Tongchao and Tan, Xinghua and Pan, Feng},
title = {In Situ Conversion of Artificial Proton‐Rich Shell to Inorganic Maskant Toward Stable Single‐Crystal Ni‐Rich Cathode},
journal = {Advanced Materials},
year = {2025},
volume = {37},
number = {7},
doi = {10.1002/adma.202415860}
}
EUVIMED