EUVIMEDEUVIMED entdecken
Crossref

Photothermal Mineralization of Polyolefin Microplastics via TiO 2 Hierarchical Porous Layer‐Based Semiwetting Air‐Plastic‐Solid Interfaces

Jiaqi Zhao, Peng Miao, Xuerui Zhang, Pu Wang, Zhenhua Li, Li-Zhu Wu, Run Shi, Tierui Zhang iD

Advanced Materials · 2024-06 · 36 (25)

DOI: 10.1002/adma.202400681 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Advanced Materials, online erschienen am 08.04.2024. Verfasst von Jiaqi Zhao und 7 weiteren Autor:innen. Beteiligte Einrichtung: Key Laboratory of Photochemical Conversion and Optoelectronic Materials, Technical Institute of Physics and Chemistry, Chinese Academy of Sciences, B…. Die Arbeit wurde bisher 32-mal zitiert (Crossref) und nennt 56 Literaturangaben. Gefördert von: National Key Research and Development Program of China, National Natural Science Foundation of China, Beijing Natural Science Foundation.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Photo‐mineralization of microplastics under mild conditions has emerged as a promising solution to plastic waste disposal. However, the inadequate contact between oxygen, water‐insoluble polyolefin microplastics, and photocatalysts remains a critical issue. In this study, a TiO 2 hierarchical porous layer (TiO 2 ‐HPL) photocatalyst is presented to establish air‐plastic‐solid triphase interfaces for the photothermal mineralization of polyolefins. The wettability of the TiO 2 ‐HPL‐based triphase interface is finely controlled from plastophobic to plastophilic. High‐resolution imaging and finite element simulation demonstrate the significance of a semiwetting state in achieving multidirectional oxygen diffusion through the hierarchical pore structure while maintaining sufficient contact between the plastic phase and photocatalysts. For low‐density polyethylene, the TiO 2 ‐HPL achieves a photothermal mineralization rate of 5.63 mmol g −1 h −1 and a conversion of 26.3% after 20 h of continuous irradiation. Additionally, the triphase photocatalytic system with semiwetting gas‐plastic‐solid interfaces shows good universality for various polyolefin reagents and products, illustrating its potential in achieving efficient photothermal mineralization of non‐degradable microplastics.

Schlagwörter

Stichwörter der Autor:innen

microplasticphotocatalysistitanium oxidetriphase interfacewettability

Autor:innen und Institutionen

  • Key Laboratory of Photochemical Conversion and Optoelectronic Materials, Technical Institute of Physics and Chemistry, Chinese Academy of Sciences, Beijing, 100190, China.
  • Petrochemical Research Institute, China National Petroleum Corporation, Beijing, 112206, China.
  • Center of Materials Science and Optoelectronics Engineering, University of Chinese Academy of Sciences, Beijing, 100049, China.

ORCID-Profile: Tierui Zhang

Förderung

  • National Key Research and Development Program of China
  • National Natural Science Foundation of China
  • Beijing Natural Science Foundation
  • CAS Project for Young Scientists in Basic Research
  • DNL Cooperation Fund, CAS
  • Young Elite Scientist Sponsorship Program by CAST
  • China Postdoctoral Science Foundation
  • National Basic Research Program of China

Zitieren

APA

Zhao, J., Miao, P., Zhang, X., Wang, P., Li, Z., Wu, L. Z., Shi, R., & Zhang, T. (2024). Photothermal Mineralization of Polyolefin Microplastics via TiO 2 Hierarchical Porous Layer‐Based Semiwetting Air‐Plastic‐Solid Interfaces. Advanced Materials, 36(25). https://doi.org/10.1002/adma.202400681

Vancouver

Zhao J, Miao P, Zhang X, Wang P, Li Z, Wu LZ, et al. Photothermal Mineralization of Polyolefin Microplastics via TiO 2 Hierarchical Porous Layer‐Based Semiwetting Air‐Plastic‐Solid Interfaces. Advanced Materials. 2024;36(25). doi:10.1002/adma.202400681

BibTeX
@article{Zhao2024,
  author = {Zhao, Jiaqi and Miao, Peng and Zhang, Xuerui and Wang, Pu and Li, Zhenhua and Wu, Li-Zhu and Shi, Run and Zhang, Tierui},
  title = {Photothermal Mineralization of Polyolefin Microplastics via TiO 2 Hierarchical Porous Layer‐Based Semiwetting Air‐Plastic‐Solid Interfaces},
  journal = {Advanced Materials},
  year = {2024},
  volume = {36},
  number = {25},
  doi = {10.1002/adma.202400681}
}
Kostenlos starten →