EUVIMEDEUVIMED entdecken
Crossref

Conversion of Dielectric Surface Effect into Volume Effect for High Output Energy

Shaoke Fu, Huiyuan Wu, Wencong He, Qianying Li, Chuncai Shan, Jian Wang, Yan Du, Shihe Du, Zhengyong Huang, Chenguo Hu iD

Advanced Materials · 2023-10 · 35 (40)

DOI: 10.1002/adma.202302954 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Advanced Materials, online erschienen am 16.08.2023. Verfasst von Shaoke Fu und 9 weiteren Autor:innen. Beteiligte Einrichtung: Department of Applied Physics, State Key Laboratory of Power Transmission Equipment & System Security and New Technology, Chongqing University, Chong…. Die Arbeit wurde bisher 157-mal zitiert (Crossref) und nennt 46 Literaturangaben. Gefördert von: Minister of Science and Technology, National Natural Science Foundation of China, Analytical and Testing Center of Chongqing University.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Improving the output energy and durability of triboelectric nanogenerators (TENGs) remains a considerable challenge for their practical applications. Owing to the interface effect of triboelectrification and electrostatic induction, thinner films with higher dielectric constants yield a higher output; however, they are not durable for practical applications. Herein, the dielectric surface effect is changed into a volume effect by adopting a millimeter‐thick dielectric film with an inner porous network structure so that charges can hop in the surface state of the network. Charge migration inside the dielectric film is the key factor affecting the output of the triboelectric nanogenerator (TENG) with a thick film, based on which each working stage follows the energy‐maximization principle in the voltage–charge plot. The maximum peak and average power densities of the TENG with polyurethane foam film in 1 mm thickness reach 40.9 and 20.7 W m −2 Hz −1 , respectively, under environmental conditions, and the output charge density is 5.14 times that of TENGs with a poly(tetrafluoroethylene) film of the same thickness. Superdurability is achieved in the rotary‐mode TENG after 200 000 operation cycles. This study identifies the physical mechanism of the thick dielectric film used in TENGs and provides a new approach to promote the output and durability of TENGs.

Schlagwörter

Stichwörter der Autor:innen

charge hoppingtriboelectric nanogenerators (TENGs)ultrahigh powervolume effect

Autor:innen und Institutionen

  • Department of Applied Physics, State Key Laboratory of Power Transmission Equipment & System Security and New Technology, Chongqing University, Chongqing, 400044, P. R. China.

ORCID-Profile: Chenguo Hu

Förderung

  • Minister of Science and Technology
  • National Natural Science Foundation of China
  • Analytical and Testing Center of Chongqing University

Zitieren

APA

Fu, S., Wu, H., He, W., Li, Q., Shan, C., Wang, J., Du, Y., Du, S., Huang, Z., & Hu, C. (2023). Conversion of Dielectric Surface Effect into Volume Effect for High Output Energy. Advanced Materials, 35(40). https://doi.org/10.1002/adma.202302954

Vancouver

Fu S, Wu H, He W, Li Q, Shan C, Wang J, et al. Conversion of Dielectric Surface Effect into Volume Effect for High Output Energy. Advanced Materials. 2023;35(40). doi:10.1002/adma.202302954

BibTeX
@article{Fu2023,
  author = {Fu, Shaoke and Wu, Huiyuan and He, Wencong and Li, Qianying and Shan, Chuncai and Wang, Jian and Du, Yan and Du, Shihe and Huang, Zhengyong and Hu, Chenguo},
  title = {Conversion of Dielectric Surface Effect into Volume Effect for High Output Energy},
  journal = {Advanced Materials},
  year = {2023},
  volume = {35},
  number = {40},
  doi = {10.1002/adma.202302954}
}
Kostenlos starten →