EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Tailoring 3D Printed Micro‐Structured Carbons for Adsorption

Stuart Scott, John Chew, Jonathan Barnard, Andrew Burrows, Martin Smith, Steven Tennison, Semali Perera

Advanced Functional Materials · 2023-08 · 33 (31)

DOI: 10.1002/adfm.202213715 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Advanced Functional Materials, online erschienen am 05.05.2023. Verfasst von Stuart Scott und 6 weiteren Autor:innen. Die Arbeit wurde bisher 31-mal zitiert (Crossref) und nennt 40 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Engineering and Physical Sciences Research Council.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The manufacture of tailored carbon‐based adsorbent structures with exceptionally low‐pressure drops and improved kinetics using stereolithographic 3D printing is presented. Adsorbent structures are printed from commercial resins with square, circular, and hexagonal cross‐sectional microchannels. These structures can reduce energy use by 50–95% compared to conventional carbon‐packed beds. The activated 3D printed carbon achieves Brunauer–Emmett–Teller surface areas over 1000 m 2 g −1 and shows outstanding butane adsorption capacities, over twice the capacity of a commercial carbon and a comparable capacity to phenolic‐based carbons. The structures also show excellent uptakes of cyclohexane, up to 0.62 g g −1 in a saturated feed. The introduction of complex axial geometries including spirals and chevrons enable superior adsorption kinetics and premature breakthrough of contaminants at high gas flow rates. These results demonstrate the success of intelligent manufacturing of low‐pressure drop, high‐capacity micro‐structured adsorbents, allowing for the development of gas separation technologies for applications such as greenhouse gas removal and respiratory protection.

Förderung

  • Engineering and Physical Sciences Research Council

Zitieren

APA

Scott, S., Chew, J., Barnard, J., Burrows, A., Smith, M., Tennison, S., & Perera, S. (2023). Tailoring 3D Printed Micro‐Structured Carbons for Adsorption. Advanced Functional Materials, 33(31). https://doi.org/10.1002/adfm.202213715

Vancouver

Scott S, Chew J, Barnard J, Burrows A, Smith M, Tennison S, et al. Tailoring 3D Printed Micro‐Structured Carbons for Adsorption. Advanced Functional Materials. 2023;33(31). doi:10.1002/adfm.202213715

BibTeX
@article{Scott2023,
  author = {Scott, Stuart and Chew, John and Barnard, Jonathan and Burrows, Andrew and Smith, Martin and Tennison, Steven and Perera, Semali},
  title = {Tailoring 3D Printed Micro‐Structured Carbons for Adsorption},
  journal = {Advanced Functional Materials},
  year = {2023},
  volume = {33},
  number = {31},
  doi = {10.1002/adfm.202213715}
}
Kostenlos starten →