Photo‐Curing 3D Printing of Thermosetting Sacrificial Tooling for Fabricating Fiber‐Reinforced Hollow Composites
Advanced Functional Materials · 2023-05 · 33 (20)
DOI: 10.1002/adfm.202213663 ↗Kurz gefasst
Fachartikel in der Zeitschrift Advanced Functional Materials, online erschienen am 26.02.2023. Verfasst von Baoming Zhao und 7 weiteren Autor:innen. Die Arbeit wurde bisher 28-mal zitiert (Crossref) und nennt 45 Literaturangaben. Gefördert von: U.S. Department of Energy, Office of Energy Efficiency and Renewable Energy, U.S. Department of Agriculture.
Abstract (Originalsprache)
Carbon fiber‐reinforced hollow composites play a vital role in lightweighting modern cars and aircrafts. Fabrication of such hollow composites with seamless internal finish requires sacrificial tooling that can be used under pressure and high temperature. For the very first time, high performance sacrificial tooling that can be used to fabricate fiber‐reinforced hollow composites is produced using photocuring 3D printing technology. This is achieved by developing UV‐curable resins containing highly soluble yet hydrolysable acetal acrylate cross‐linker and hydrophilic 4‐acryloylmorpholine monomer. It is found that the cross‐linker content greatly affects the printing speed. Further, the widely adopted UV post‐curing method is found to have negligible impact on improving the thermal‐mechanical properties of printed structures. After thermal post‐treatment, printed sacrificial tooling exhibits a heat deflection temperature of 112 °C at 0.455 MPa and an average coefficient of linear thermal expansion of 59 ppm °C −1 between 30 and 100 °C. As a result, printed tooling enables fabrication of carbon fiber‐reinforced hollow composites with complex geometry, which shows a tensile strength of 802 MPa and an elastic modulus of 50.2 GPa.
Förderung
- U.S. Department of Energy
- Office of Energy Efficiency and Renewable Energy
- U.S. Department of Agriculture
- National Institute of Food and Agriculture
Zitieren
APA
Zhao, B., Hao, C., Chang, Y., Cao, Y., Liu, T., Fei, M., Shao, L., & Zhang, J. (2023). Photo‐Curing 3D Printing of Thermosetting Sacrificial Tooling for Fabricating Fiber‐Reinforced Hollow Composites. Advanced Functional Materials, 33(20). https://doi.org/10.1002/adfm.202213663
Vancouver
Zhao B, Hao C, Chang Y, Cao Y, Liu T, Fei M, et al. Photo‐Curing 3D Printing of Thermosetting Sacrificial Tooling for Fabricating Fiber‐Reinforced Hollow Composites. Advanced Functional Materials. 2023;33(20). doi:10.1002/adfm.202213663
BibTeX
@article{Zhao2023,
author = {Zhao, Baoming and Hao, Cheng and Chang, Yu‐Chung and Cao, Yiding and Liu, Tuan and Fei, Mingen and Shao, Lin and Zhang, Jinwen},
title = {Photo‐Curing 3D Printing of Thermosetting Sacrificial Tooling for Fabricating Fiber‐Reinforced Hollow Composites},
journal = {Advanced Functional Materials},
year = {2023},
volume = {33},
number = {20},
doi = {10.1002/adfm.202213663}
}
EUVIMED